معلومات عنا
دعم العملاء
احصل على التطبيق
قم بتوجيه الكاميرا لتنزيل التطبيق
حقوق الطبع والنشر © 2024 Desertcart Holdings Limited
🚀 Upgrade Your 3D Printing Game!
The Creality Direct Drive Extruder Upgrade Kit is a comprehensive solution for enhancing your Ender-3 series 3D printer. This all-metal kit supports 1.75mm filament, including flexible options like TPU, and features a user-friendly assembly process with included tools and instructions. Designed for durability and efficiency, it minimizes nozzle blockages and maximizes printing versatility.
| Brand | Dawnblade |
| Manufacturer | Dawnblade |
| Model | Dawnblade201122 |
| Package Dimensions | 16.61 x 15.6 x 9.19 cm; 740 g |
| Item model number | Dawnblade201122 |
| Operating System | Windows 10 |
| Printing Technology | FDM |
| Compatible Devices | Personal Computer |
| Mounting Hardware | steeper motor |
| Number of items | 1 |
| Voltage | 24 Volts |
| Batteries Included | No |
| Batteries Required | No |
| Material | Aluminium |
| Manufacturer | Dawnblade |
| Country of Origin | USA |
| Item Weight | 740 g |
B**T
Fantastic upgrade for Ender 3! No more clogged feed tubes!
Moderate level of difficulty, no instructions in the box, found a YouTube video by Lost in Tech that helped a lot!After install the prints were great and I'm no longer worried about clogged feed tubes!
S**X
Major pain to install in CR-10 but worth it.
I'm into building and flying FPV quadcopters and many of the add-on parts are 3d printed out of TPU (thermoplastic polyurethane). TPU can be difficult to print especially with a bowden tube extruder setup. So I ordered this unit to make printing in TPU easier. This unit was designed for the Ender printers but will work for the CR-10 printers but YOU MUST INSTALL A 12 VOLT HEATING CARTRIDGE IN THE HOT END FOR CR-10!!! This unit is shipped with a 24 volt heater for the Ender printers. This information is not clearly written in any of the literature so hopefully I can save you some head scratching. The install of this unit onto your gantry is easy but the WIRING INTO THE BOARD can be quite tedious especially on the CR-10. The pain in the baltz is worth it however as I was getting very nice TPU prints IMMEDIATELY. Bear in mind that you must change your print settings significantly from PLA to TPU but there are lots of YouTube vids etc for that. All in all this is an incredible setup, especially for around $30 usd.
K**R
Easy install, be sure to check bottom wheel bolt
Very easy install, especially if swapping existing extruder you can just swap all relevant wires. However I ran into headache trying to figure out why the extruder was getting blocked moving left on x axis, turns out whoever assembled put the bolt on wrong way so I had to disassemble and flip it as shown in picture.
G**A
excellent
excellent
J**S
Quick easy install for quality prints
Installed this on my Ender 3 after my original hot end died. For an extra $7 over the cost of a replacement hot end this was a no brainer. Took a few minutes to change the wiring but aside from that it went together pretty quickly. Unit came completely assembled and was easy to install with the aid of a video on youtube.
ترست بايلوت
منذ يوم واحد
منذ أسبوعين
