CLOUDY BAY [6 Pack] 3CCT Low Voltage LED Deck Lights Outdoor,2700K/3500K/5000K Selectable,Landscape Step Stair Railing Fence Light Wired,3W,12V-24V AC/DC,Bronze

Easy to install. Aluminum housing is durable and lights included waterproof gasket and wire nuts. 3 color settings for LED lights. Lowest LED light setting was preferred and provides adequate illumination.

These lights were great replacements for our aging halogen lights that were almost exactly the same size. The multiple color settings (3) on them was appreciated and installing them was easy.

Work well, look great!

These are well built lights that work with a standard 12v landscaping system. They have 3 different light temperatures to choose from. Installation was very simple. Just drill a hole for the wire (3/8), and two smaller pilot holes for the mounting screws. The casing is made from aluminum and is very durable. The only issue I found, was in a couple of the lights the switch to select the temperature of the light were broken. I contacted the vendor through Amazon, and they are sending out replacements.

Excellent stair lights. Aluminum, well coated and brilliant. Can also connect them with a little LED driver as I did. Hope they last as is the main problem faced today with LEDs, they all die in 2 - 3 years

Great little lights little pricey, but great little lights. I had a lightning strike and a blew a few of them out but all in all great little lights.

Look and work great! Would buy again!

I love the look / appearance of these deck lights. They were the only ones I found that would compliment my newly stained deck.However, when I opened the box to prepare to install them, it was difficult to separate the base from the cover, in order to mount the bases to my deck.Once I got them opened, it was nearly impossible to get the covers back onto the bases: they did not want to turn far enough to align the lens in the cover with the LED platform in the base.It seemed as though the slots in the bases were too small at the distal end to permit the flange on the cover to turn to the proper position.As a result, if I mounted the bases level to the deck, the covers would be all crooked and also the LEDs would be at an angle other than 90 degrees from the lens, and would not evenly illuminate the deck.If I removed the silicone gasket, the covers could easily turn far enough, but that would not be acceptable, since it would permit moisture to permeate the lights.I finally had to use a rubber strap jar opener to close all the fixtures enough to align the covers with the bases.This was extremely frustrating, and I suspect very few customers would go to that much trouble, so I thought you might want to know about the trouble I found, and how I resolved it.