POWERTEC 71084 Zero Clearance Band Saw Table Insert for Jet Bandsaw Models, 2-1/2” Outer Dia. x 1-3/4” Inner Dia. – 5 Pack (Color May Vary)

Just like a lot of people from the reviews said, the inserts are slightly oversized, but they’re easily “persuaded” in with a rubber mallet.Nevertheless, this is a good value for the money and I would buy the inserts again.

Easy fit

I have a Jet JWBS-14CS bandsaw. After modifying, this fit perfectly. Two mods were needed: 1) The pin that keeps the original throat plate from rotating needs to be removed or pounded down flush with the lip that holds the plate, and 2) cut some plastic away from the bottom to allow for the wider lip near the pin (in other words, the lip is not a true circle, but the insert is).

Ridgid BS14002 not the best fit but a little trickery it’s perfect. It doesn’t fit flush to the table top and it is a little loose. However I put a little dap of hot glue around the edge and it fits snug as a bug and it’s flush The price is right. I have 4 stars because I had to use mind over matter 🦘

I have an old Delta/Rockwell bandsaw, which has the blade a bit offset from the center of the insert. So, to keep the kerf line within the thinner portion of the insert, I had to twist it a bit to go from one corner of the thin portion to the other. It's a bit hard to explain until you see it. But it worked fine. You may have to sand down the leading edge of the insert as it's built to be a little larger than the space (which probably makes sense). I hammered mine in and it still had a bit of a lip all around, which is why I had to sand down the leading edge so material didn't get caught on the front of the insert. Recommended, but not exactly perfect for my saw.

It fit my machine and works as it should.

OK product would not buy again

I used these on a 61 year old Delta 14” bandsaw. As others have noted, they require some fiddling to fit. They also detail how to trim them for a good fit. Since I lack patience, I simply cut a kerf for the blade and pounded them in with a small rubber mallet. Worked perfectly and they sat tight due to the forced fit. To remove, I simply tapped from below using a dowel. I used these with a dust collector and it worked well and left almost no sawdust in the base. Only other thing I would note is that for resawing, widen the kerf just a bit since the side of the holder will scrape a bit of sawdust off the blade leaving it on the table it it’s too close to the blade. Once I widened the kerf about 1/32, problem solved.

Exacto lo que pedí y queria

Would have given 5⭐️ but had to customize to fit it in. Older saw could be why(3wheel)Happy though, good price!

Fit my Delta bandsaw perfectly

I have a 15" Canwood 10-250 bandsaw, for which I'll never find the OEM part. These inserts are a hair oversized, but I was able to get it to fit with a bit of shaping with a belt sander. I haven't used it in anger yet, but looks to be a tight fit, and is flush, so I don't anticipate any problems.

The media could not be loaded.  Although they claim these are for Delta bandsaw, they do not fit mine.