Steering Neck Bearing Race Remover,Motorcycle Steering Neck Bearing Race Removing Tool Universal for 1‑1/8in to 2‑5/8in ID Races

This works to pull the inner bearing race from HD wheels that use tapered "timken" bearings. However, be careful because you can cock the race and it will bind.The issue is that the puller ears give surface that is not flat to punch against. If you use a 1" pipe or whatever and just start pounding it can load one side and bind the race.The solution is to:1) First, use emory paper or sand paper to clean up the wheel bore.2) Smear a little grease or oil on the bore.3) Rotate your punch as you tap the race out, being careful to alternate between the two ears.If the race starts getting cocked, square it up with a race/seal install tool and start again.Overall, the tool does the job fine and is cleaner than the old "weld a bead on the race" trick. I suspect it works even better on the larger neck bearing races it is actually designed for.

By placing a chisel and grinding the shoulder on it making a wedge I did manage to get the race out I would buy better quality if I had to do it again

Great value, can't beat the price.Great for pulling races out of HD rims.Highly recommended.

Worthles POS, the lip keeps sliding past the race thanks to this ingenious design where the bolt already puts the lip at an angle when expanding. Totally not worth even 1 star.

If you remove races often spend the money and buy a good one. I almost had to alter it in order for it to work….

2007 Road King stem Bearings.. I couldn't get the tool to catch the edge of the bearing because the edge of the tool is a little thick. I knew it might be the case based on previous reviews. Hit the bottom corners on the belt sander for a minute to thin out the edge and it worked fine.