Hand Free Universal Work Holder, Peg Clamp Base Vise Bench Tool Set for Jewelry Making with 8 Pin

You will need to do a bit of light sanding on the vice face, and the rods provided are maybe 0.01” too small in diameter so some slippage might occur. Otherwise this vice does everything for my gunpla and I cannot recommend it enough. The base is detachable if you want a handheld vice and it is a hefty little guy. Seriously recommend.

Excellent for my use, holding jewelry to work on it. Seems quite robust yet sleek

Pins are a bit sloppy. Under pressure they tighten up but I have had them fall out while getting set up. Pivot point doesn't take a lot of carving pressure but works fine with my Dremel.

Great love it! Works perfectly

As several reviews mention, the pins as delivered are rather loose. The vice will still work with these pegs for holding smaller objects. I measured the peg holes and realized I could easily ream them to 3.5 mm diameter, and used some 3.5 mm brass rod to make new pins. These work very well, especially with some silicone tube over them to give a soft clamp. The main clamp is also a bit loose - i.e., not completely rigid when tightened as far as I am willing to go. It is by no means loose, and this does not matter at all for me; it is plenty tight enough for what I do, soldering, gluing, etc., but if I were drilling or engraving, I would mount the top of the top part of the vice in a more rigid vice. For the money, I am very happy with the purchase