SINCODA USB 3.0 Mount Cable-6 (Round Single USB3.0)

Works Great. I removed my dash bezel and removed the cigarette lighter and put this in place of it, It was a direct fit! I have 2 cigarette lighters in the bezel, so it was an easy choice to replace one of them, then I ran the USB to the back of my KW headunit, Android auto and apple play work seamlessly. DO NOT over tighten the nut on the back, or you will strip it out. I would recommend this purchase!

Out of the box ready to use. Fits in the cigarette holder of my Jeep with little modification to the Jeep panel itself. Purchased for my double din radio install. Looks almost factory. Highly recommend.

This panel mount extension port works great and connected to my new receiver without trouble. Using it for Apple Car Play in the car. Syncs without trouble. Audio AUX port is full stereo. Cable is plenty long enough for the port to be mounted in the center console if you wish. Only thing keeping it from a full 5 stars is the mounting bracket that was supplied, The port doesn't fit properly in it. The inner threaded body is way to small and floats around, the larger flange body is big and doesn't fit the round opening. Had to 3D print my own custom mounting bracket that is shown in the picture. The round hole is about 1.175" in diameter the flange part of the port fits snug. All in all its a nice port and works well. I would buy again and would recommend it.

This worked great with my Kenwood double din receiver that only has USB on the back.. i was able to remove the cigarette lighter port from my Tahoe center console and with a little widening of the hole, just run the wires through and secure it. Works great! 👌🏻

It works fine. The problem is more with the caseing. The USBs are very loose. And often causes what ever I connect to it to fall out. I know it's not being pulled by anything because it's in my middle console.

I used this to install an aftermarket touchscreen with ApplePlay into my wife's 2009 Wrangler. Replaced the original outlet on the driver side. Looks factory and works great!

Used this on an install of an Alpine media head in my daughter’s 2010 Toyota Prius for CarPlay connectivity. This extender/port worked perfectly with no issues but it was smaller than the blank already on the car IP. Had to cut a hole below the blank but that wasn’t a big deal. On of the retaining wings did break when I locked it in place but the other 3 were fine so not a big issue.

Bought this to put a USB port for charging and using Apple CarPlay in my Honda Element (which doesn’t have a native USB port) for a new stereo system I installed. Works perfectly for my needs