grip puppy Comfort grips for BMW Models

Man, I LOVE these things. I ride an old BMW R1100RT which is a brilliant bike, but it’s a boxer and has a bit of vibration through the bars at highway speeds. These puppies not only greatly reduce that, but also feel great-I am 6’6” tall and have hands like shovels, so the way the Grip Puppies expand the diameter of the grips and make everything feel thicker and chunkier in the hand is brilliant for me. I also have bilateral carpal tunnel syndrome and the puppies make riding much easier on my wrists. I like the chunky look of them too, I cut 8mm off the end of each of them to make them fit the grips just right and they went on easily. I didn’t use the soapy water method, I used a long thin screwdriver inserted inside the puppies to “walk” them onto the grips. The whole installation took less than ten mins and I was on the road shortly afterwards! Very much recommended. An inexpensive solution which made my old tourer feel much more comfortable!

Perfect addition for your motorcycle. Only downside is you have to cut them to fit.

I was getting a fair bit of vibration through the handlebars of my BMW G310r at certain revs and decided to give these puppies a go instead of changing bikes. After trimming off a cm on each one they fit snuggly over the existing grips (coersed by some Fairy liquid and a touch of elbow grease) and feel comfortable in the hand. The grips are now a fair bit bigger than they were but I'm sure I will get used to it after a few miles. Vibration is not eliminated but is greatly reduced.

Love these - had them on all my bikes over the last few years. Less vibration, but not too thick that you don't feel the grips. Oh, and they work over heated grips as well (i.e. they let the heat through to keep your hands toasty). Ignore the mention of BMW - they're a generic fit, so suitable for pretty much all bikes.

Very quick and reasonable postage abroad, (Portugal). Very happy with them on my Vulcan S as the original grips are of a small diameter which caused my fingers to cramp. These “fatten out” the grips and make a very comfortable hand hold, their vibration absorbing properties are an added bonus. I didn’t want them to rotate on the factory grips once installed so chose not to wet or soap them. Instead, I installed them by removing my bar-end weights (so they didn’t get scratched) and then offering them up to my original grips and applying my air-gun at about 120 PSI inside the Puppies where they met the original grip, then just wiggling them on. They didn’t need cutting on this bike and each side took about one minute to fit. After refitting the bar-end weights the installation looks factory. Interested to see how long they last…

Took a while to figure out how to fit. Found soaking in hot water and smearing washing up liquid on the existing rubber grips worked a treat really easy then! They have increased the diameter of the grip and I think they have reduced vibration a bit but not completely. However the increased diameter and grippiness means an overall reduction in the effects of the vibrations. They were recommended to me and I’m pleased they were.

Easy to fit,comfortable and reduce vibration a lot.

Comfy but a real struggle to put on. If you use enough soap for them to be forced on (even after a soak in v hot water to soften them) they don't grip the original grips at all well - hardly surprisng. So a mixed review.

Perfect solution, way more hand / finger comfort. Highly recommend