R REIFENG 4pcs 2M Motor Connector Cables XH2.54 4pin to XH2.0 6pin White Terminal Paralled Motor Wires for 3D Printer Stepper Motor

Works great as a replacement for the stock ender extruder cable. As everyone else mentions you need to swap two wires. You can swap green and black on the six pin and quite easily. Attached photo is the correct orientation.

all good

Fortunately it was not too difficult to pull out the 3 pins that needed to be rearranged so overall a good product.

Like many others have said, I had to swap the wires/pins but it is easy to do so. All four worked perfectly and I love the long cables. Im rough on these cables in my 3D printers for some reason, and had two fail of another brand in less than a month. These have lasted me and dont seem to be having any issues at all.

These wires work for 3d printer stepper motors and the length is as advertised. However, the wires were not aligned correctly for my stepper motor (creality 42-40, z-stepper motor) and mainboard (Bigtreetech SKR Mini E3 v3). The correct wiring when looking at the back of the six-pin connector (the side with the two raised slots), from right to left, Red, skip, Green, Blue, skip, Black. It may be different on your main board. Compare your other stepper motor wires to this one and just rewire to the correct sequence (your other stepper motor wires should be color coded or have specific markings on the back to indicate the differences). The wire terminals are easy to remove from the connector on the front of the six-pin connector; there are little white tabs that you can wedge up with a very small screwdriver (or thick needle, pin, or similar size pointy object) and pull out the connector (just be careful not to break the tabs).