LED BAR Tail Lights, Smoke Square Brake Taillights for Jeep Wrangler TJ YJ CJ-5 CJ-7 1979-2006, Stop Turn Signal Reverse License Plate lamp w/Side Marker Light Assembly, 2PCS

I have a 2003 Jeep Wrangler sport. I just installed the tail lights. Pretty straight forward. I did solder and heat shrink all my connections. I did drill a small hole in the back of each tail light to feed the ground wire back through and wrap around one of the bolts before tightening and it worked great. A really great upgrade from the old worn out lights.

Quality product. They look great on my jeep

The good: They provide an updated, modern look. The running, stop and turn LED lights are highly visibile. The bolt pattern matched that of my TJ Wrangler exactly.The meh: The units come with a black ground wire that the instructions say should be attached to the ground wire of the vehicle. The Wrangler TJ has no ground wire. Rather, in the stock lights, the lamps have a metal base that is attached to a metal plate through which the mounting bolts pass, grounding the lights to the chassis. The new units do not have a metal base. So, you need to tap into the black ground wire inside the light enclosure and run a short wire to a ring terminal and pass one of the mounting bolts to the ring terminal.The bad: The back-up light is dim and less bright than the stock reverse light. It has a milky white plastic lens that blocks most of the light. It serves only to signal other drivers than you are backing up and does not provide any back-up illumination. The second, but minor, bad thing is that the supplied screws for attaching the LED light assembly to the back case are too short. I had to make a trip to Home Depot to get longer screws.TJ installation notes: I consulted the OEM wiring diagram to identify the color codes for the stop, turn, running, and back-up lights, but when I wired the new lights accordingly, they did not work correctly. It turns out, surprisingly, that the OEM wiring diagram has the color codes mixed up, which I learned from an online Wrangler discussion forum. Here are the correct color codes for my 2004 Wrangler TJ: Left brake/turn light: green/red. Right brake/turn light: brown/red. Running lights: black/yellow. Reverse light: violet/black. Note that the Wrangler does not have separate circuits for the brake and turn lights. The onboard electronic control module pulses the brake lights to create the turn signal.

They stand out . I was not satisfied with the old stock taillamps . These are good, good price, ez to install, and bright .

Good product and fast delivery

PERFECT! I searched for ages to find an aftermarket light that was actually for a TJ not "universal". These matched right up to the factory holes and have the side reflectors. The brightness is incredable even at high noon sun. They look great and function as my expectations expected. The lcense plate light is super bright, almost works like a super puddle light in the rear. I did heat connect my wires using the factory plugs and made the ground attach within the housing. If you are looking look no further.

Side marker on one of the tail lights does not work, also when I wire in with the reverse lights, the reverse light comes on when I hit the brake so something internally is messed up with my order, I will not be purchasing from this company again and I expect some type of compensation because now I don’t have taillights on my only vehicle

They look pretty good . Now if you have the taillight brush cage like I do it is difficult to negotiate around the lens as the wires are short inside,this fumbling caused a pin to loosen and come apart for the side marker. After removing the entire assembly to reattach ,also used a little spot of glue to prevent it coming apart again, the end result was worth the effort. This is a splice in deal, wiring shouldnt be too hard to figure out I just looked inside original light fixture and trace wires to their bulbs. Elementary.