FivePears 3/4" Radius Roundover Router Bit 1/2 Inch Shank, Round Over Router Bit for Edging Forming Rounding

This item works well as i had purchased it for my husband, he hadbprevously hadbone andbit got broken, no hassles, it works well.

have not used them yet, they are sharp, I am not a pro wood worker, they will work for me, the box they come in is not the best, I will have to make one to replace .

The bearing seems good and got the job done. Did not seem as sharpe as it could have been and I got a little burn and a few edges.

The media could not be loaded. I bought this to cut a radius on an aluminum square bar expecting to barely get the job done and destroy this inexpensive bit in the process. It took me 2 hours or so taking very thin cuts and feeding bar through very slowly to finish all 4 corners. I'm very pleased with the finish on the cuts and even more pleased that the bit sustained no damage and is just as sharp as when I got it.

Good bits wrong router. Maybe for a table router

Needed a 1/2" round over bit to make a better looking edge for a table I was making. Bought an entire set of bits from FivePears based on Amazon description and customer comments. Was very pleased with the high quality, clean cut I got from 1/2" bit and will use the other bits as needed

Seem to be good quality. Fyi, don't try to use as a router bit in a radial arm saw. Too much slack so to speak. Work fine in a real router.

I just made this vintage spec. Jazz bass body. In researching I found that 7/16 is the correct corner radius. It worked out perfect. I’m pleased with the results.