Garage Door Sensor Beam Eyes, Garage Door Safety Sensor Replacement Parts Compatible with Liftmaster/Sears/Craftsman After 1997 (41A5034, 801CB-P) No Bracket

Very easy to install, and worked perfectly.

Easy to install and perform great.Seems to have fixed my problem and saved me a service call.

Compatible. Works fine

Easy install, works like a charm!Almost zero learning curve with these, the install went very quickly and smoothly with my door. A few cons: 1. If the send and receive were marked, I couldn't tell and I ended up installing them in reverse order. 2. My original sensors would blink if something was in the way, as far as I can tell, these do not.I did test them and they work fine. The stopped the door as expected when the line was crossed.All in all, they are pretty good considering the name brand replacement is 4x as much.

I had some trouble with my garage door, and after checking out various forums, everyone kept saying to swap out the garage door sensors, so that’s what I did. They were pretty affordable and had solid reviews. When I went to install them, I had to cut the old wire that connected to the old sensors and tossed those out. I then spliced the old wire, stripping about a quarter inch of the rubber insulation to reveal fresh wire. After that, I used the connectors that came with the new sensors to join the old wires to the new ones. I’d never used connectors like this before, but they were pretty straightforward. All I had to do was match positive to positive by inserting one of each into the connector, then just pressed down on the orange cap with pliers to secure them. I repeated the same process for the negative wires. Luckily, I could use the existing mounts from the old sensors, and within minutes, my garage was back in action!

These worked well. Just wired them in faced each other and my door works

I have an old Wayne Dalton garage door made in 1998. My old sensor just quit functioning. This replacement works perfectly. It seems to be a good quality. Very easy to install. The brackets fit very snug on the door guide, no screws or special tools needed.

i got them to work , but they have the LED light on the same side as the bolt, so i could not see when the two alined, i got lucky lining them up . they work fine thought.