Master Manufacturing Cordaway 2" Desk Grommet, Adjustable Cord Cover, Cable Hole Wire Management, Three Different Sized Opening, Made In USA, Black Plastic (00201)

Purchased these to easily hide and organize my PC cables. Fit the 2" drilled hole perfectly. Worked as expected. My desk looks great.

Just as advertised. I saw some postings saying this needed a 2-1/4" hole, but the one I received clearly said a 2" hole saw and I measured and used a 2" hole saw with no problems. The piece fit fine in the 2" hole.Works perfect as a very inexpensive desk grommet for my computer power and data cords.The outer shell is just that - a plastic shell 2" outer diameter plus a flanged and beveled top that extends out past the hole a good 1/4". Even if you aren't precise about your 2" hole, this won't fall in unless you cut a 2-1/2" hole.The top insert that snaps into the shell is a two-piece unit. The lower piece has three different-size gaps cut in it, in case you really want to be picky about your cords. The upper piece swivels around to let you pick any of the three holes, and helps to close up any gaps if you are using a little larger lower gap than you need. The insert snaps into the lower shell securely - it won't pop out just by moving a cord a little bit, but it is easy enough to pop out to change cord arrangements.

This is a nice piece. After reading bad reviews for other gommets I "splurged" on this pricier one. It is slightly too small for my 2" hole, a few wraps of electrical tape made it snug. The cover comes off easily and has two different opening (small and a bit less small) to run wires. If you're trying to run a few PC power cables and video cables through it you probably won't be using the cover. Happy enough that I'm buying two more.

My son’s IKEA desk grommet cracked and I thought this would be a direct replacement as it measured 3” on my measuring tape but sure enough it’s just slightly smaller than this item so I had to dremel the hole a bit to fit.

Fit a 2" drilled hole perfectly. I had put a hole into a built-in desk in my rental so that cords wouldn't be going over the front. I had been looking for something to make it look cleaner and finally settled on this. It fit the hole snugly and makes it look much cleaner. Including a picture of the back of the package. I would have ordered sooner if i had been able to see the installation guide for hole sizing.

After reading many reviews for similar items, it seems a common issue was that the grommet was not of the actual size stated. I ordered the 2 inch version and it fit snugly into a hole created by my 2 inch hole saw bit. I was a little concerned that it wouldn't fit all all of the cables I needed to run, but it will fit 4 cables of the power or Ethernet sized diameters on the largest setting. Not sure it would fit more than that. Its also nice you can order a single one instead of a multi pack when you just need one.

The inside diameter of this plug is a bit smaller than 2" which means it is a bit loose in a true 2" hole. The problem with that is if any cables put tension on the side of this, it will pull up out of the hole or sit at an unsightly angle. I'm probably going to have to apply some glue to the side of this to get it to truly stick in my hole and not pull up. See the attached picture to get an idea of what I'm complaining about.Other than the poor fit, this is fine. But since the whole purpose for me buying these was to have an aesthetically pleasing hole for cables, having the grommet sit at an angle is not really delighting me.

I needed to route some cords out of a PVC set up for my snake, so I got a 2in circle saw and it matched almost perfectly. It had a slight wiggle/gap so I just applied a couple layers of plumbers tape and it fit in great.