BIKETEK Motorcycle Motorbike Front Paddock Stand Front Fork Stand Series 3 Red

I needed a stand that was tough enough to take the better part of a 27 stone Hayabusa ! which the stand seemed to do OK. It's made of very solid tube and is well coated in a thick paint. The wheels also seem very solid. I had to go on youtube to see where the rubber bits were ment to fit on the forks as no instruction in its safe use is included. I know you may feel this may be obvious but you don't want to take a chance with a good few grands worth of bike, if the bike fell off the stand onto its forks and then onto its side it would cost a fortune to put right. But this is a small negative about what I think is a worth the money product.

Had the BikeTek rear stand for about 4 years now and cannot complain. Its not perfect but for this kind of money it is well worth it. Recently I decided to finally get the front stand too and did not think too long to buy another BikeTek.It took only about 5 minutes to put together. So far I used it a couple of times and I have no issues with it. Lifting my bike is easy with it. Stand works well and keeps the bike stable.

Solid, easy to use and does its job. Came quickly. No fuss. Would recommend to anyone looking for a front paddock.

I bought this to raise the front end of a Suzuki Vstrom 650. It is made of robust steel and welds but unless your bike has the lugs at the back of the fork legs (which hold the brake calipers like a GSXR for example) there's a bit of Heath Robinson required to stop it rolling off the 2 pins on either side. There's some vids on Youtube involving jamming screw drivers in etc. Got there eventually. That said it's relatively cheap compared to others which gave it the fourth star.

Very easy to use ! Fast delivery !Great product !

Lifts the front of my 600cc motorcycle in seconds, feels study and looks good in red. Can't complain, great product.

I’m not one for writing bad reviews but I thought you fellow bikers should know this steer clear of this hazard of a paddock stand so I bought a set front and rear the rear one is usable bit fiddly but will hold the bike didn’t look like it would slip off but the front one is NO good the arms on the cups have rubbers over them there just pushed on so slip off when your taking the weight of the bike secondly the cups pivet as you lift the bike that’s noting new but these ones pivet to much meaning one is Turing more than the other Iv got a 600 maybe a smaller lighter bike wouldn’t have this problem but if your reading this be warned last of all of you manage to actually get the front wheel of the floor you can’t get your front wheel shaft out as it hits the top of the stand 🤣 another thing for you to keep in mind if you buy these I didn’t feel comfortable leaving my bike on this stand over night

It does the job, not the most sturdy/ secure unit I've used but for its price its perfectly fine, think when this one dies of death I'le be looking at BikeTeks squared alloy ones, I've used them since and very much like.