KATSU Two Jaw Gear Bearing Puller 4 Inch (40 x 80mm), Thin Claws Carbon Steel Mini Arm Puller Removal Hand Tool for Car Motorcycle Auto Reparing 450492

Used to pull the drive gear from the end of the crankshaft of a trials bike. Worked a treat.

I bought this to pull some wiper arms off , didn't really work , but that was my fault for not getting the right tool and not the tools fault.Seems well made and is pretty tough , nice thick cast metal , should be useful as a small puller so will keep in my toolbox for future use , I would recommend

ok kit for the price it's a bit rough round the edges but does what it's mean too

Bought these to remove a couple bearings from a vacuum cleaner motor, the pullers worked well, have since used them to remove more bearings and once again, did the job.

This was a very cheap puller, but rather poorly cast/forged. It needed quite a bit of hand filing to make it really useful.

Exceptionally good tool. I involve in changing bearings for small motors and vaccuum unit, when it comes to removing the small fan, I always struggle with the relatively big pulleys I have until I stumble on this little devil one. What I most like about it is the two adjustable locking screws. They lock the arms tightly to the grove on the impeller and under the bearings.👌👌👌👌👌👌👌👌👌

Cheap rubbish ..spend a bit more and buy a decent one

This product was purchased to remove a wiper arm which was stuck fast. This item was ordered on Prime next day delivery and it arrived as expected. The "jaws" at the bottom aren't huge and I had a little issue getting it grip properly under the wiper arm, however, it did grip when tightened enough and I used one hand to steady the item and the other to turn the screw. It worked as required and removed the wiper arms with very little effort.

Utiliser pour extraire un roulement de moteur dyson.Parfait.

Estaba bloqueado sin solución y con esta herramienta conseguí arreglarlo.

Fa ottimamente il suo lavoroÈ anche molto robusto

Les Mord sons trop petit, il a chipé deux fois et je n'ai pas ut mon pignon car l'acier des mord est beaucoup trop tendre et il ses écrasé maintenant l'extracteur est déjà bon pour la poubelle, encore une belle camelote chinoise

Very good