Electric Magnetic Lock 60KG 130LBS Holding Force Electromagnet Lock 12V Fail Safe NC Mode Single Door for Access Control System

Works perfectly as described. Easy to install. Great hold.

I installed this on my garage entry door for added security. It works great! Installation isn’t too bad if your’re handy.

This Mag Lock works as intended. I connected it up to a 12v tigger + relay on a home automation system and it works well.2 things to consider:1) The brackets are not adjustable. So when you measure and intall the magnetic part, you have to be exactly precise. It would be nice if they were slots instead of holes so you could adjust by minor amounts as needed. Not a huge deal, just quality of life.2) It does not come with rubber gaskets/washers for the metal plate. It does come with plastic washers. But mag locks typically work best when the metal plate can pivot slightly on a single anchor point in the middle. (because the mag will not latch on if the plate is not squared up with the mag part perfectly so the pivoting allows this to happen). The rubber washers/gaskets are more flexible than the included plastic ones. So you might want to have some small rubber gaskets handy and mount the mag/plate appropriately. But I was able to get mine to work with their plastic ones with some adjusting.I have gone back and purchased a second one of these for another cabinet. So they work well.

These came with everything needed to install, saving me time when it really counted. So far they have functioned beyond expectations. This lock holds tight and was a great value in my opinion.

The holding force of this magnetic lock is solid and works well as advertised. However, the included screws are very cheap and prone to stripping or breaking during installation. I strongly recommend using your own higher-quality screws for a secure and trouble-free setup.The power connector design is a major flaw. The circuit board is positioned right next to the end cap, leaving almost no space to insert and tighten the wires without risking damage. Attempting to do so will likely break the solder connection on the board. To avoid this, you must remove the end cap and either move the board inward or connect the wires with the end cap off.Overall, this lock can be a decent choice if you have the tools, knowledge, and patience to deal with its shortcomings. It's priced well for what it offers, but if you're looking for something easier to install and more reliable out of the box, consider a better-made alternative.

Weak and will not hold a door closed.

This magnetic lock is a solid performer. It's strong, easy to install, and keeps things secure. The fail-safe design gives me peace of mind. Highly recommend it for anyone looking to upgrade their door security.

Fast delivery. Good quality