Wigearss 7 In 1 Joystick Repair Kit with Opening Tool for PS5 DualSense Controller

These ate NOT plug and play like other controller joysticks. These are soldered in by two 3 prong resistors, a 4 prong button and 4 shield prongs. So you have to desolder 14 prongs to get each old one out. They are also using much stronger solder so it takes more heat to desolder. I did a lot of research and found that if you use some flux and melt some soft solder into the existing solder then it will make sucking the solder off each prong with a plunger much easier.I also found that carefully popping the old resisters off the sides of the old joystick and removing them individually then cutting the prongs to the joystick shield/housing makes it WAY easier to remove. This just leaves the 4 prong button and if you get enough of the solder off ahead of time then it comes out fairly easy also.I used a combination of heat gun and soldering iron. I've never done this before but have experience with similar jobs. It's not impossible, but has taken me a good amount of time making sure not to damage the controller. I could not get all the solder off so it did take some heat and pliers to get the old parts off.I will update this once I get it all back together an tested, but wanted to get my initial installation posted.