Burner, Heat Plate for Master forge 4 burner

So pleased . . . the grille did not have a serial or model number, but the old burners came out easily - measured them 3 times . . . and ordered - perfect fit - perfect function - even burn - perfect blue flame Did not use the igniters since it would have meant taking the thing apart - so using a butane lighter

This works for the Master Forge 1010048. I replaced the entire inside in under 1/2 hour. You will need to use the enclosed clips to extend the tents so that they reach the shelf on the bottom of the grill case. Cooked twice on it since then and everything works like it did when the grill was new. No need to drop $300 + on a new grill. If you bos is good this is a great solution.

I have a Master Forge 1010048 Grill and purchased this kit. The burner tubes and electrodes were a perfect fit. The burner heat plates in the kit were 14 7/8" in length while my existing heat plates were 15 1/8". This 1/4" difference is critical as the Hisencn plates to not fit properly. However I did find on Amazon the correct heat plates made by Kalomo. The Kalomo were a perfect fit. With that said this is a great kit. Just for my Master Forge the heat plates did not fit.

This is a great replacement set to get your grill up and working again. Installation was fairly easy and everything worked well except for the burner covers as they are a little short in length for the Master Forge grill I have so I had to install some additional bolts to hold the burner covers in place. We'll will see how if hold up overtime but for $34 I'm satisfied with my purchase.

Delivery was next day fast and packaged well. The Product quality was better than the original parts, the installation was simple while slightly different requiring some modification. The condition of the "firebox" did not allow for the use of the cotter pin attachment. The extension clips for the flame suppressing "tents" are a little touchy but they seem to rest within the fire box indentations, which was not the best design to begin with as they always required deft placement to remain securely in the minimum recess. All together it was a more than satisfactory replacement procedure given the deterioration of the original firebox.

The price was great. Because grill plates were short, I had to fabricate angle steel and attach to back wall of grill. Attached burners to rear burner rests with 4 of the 8 metal clips which came in the box. ( They had no known function.) Connected igniter wires to old piezo electric block but had to open the lugs with a screw driver. Burner holes didn’t line up with igniter holes so I forced them to work. However, after 3 hours I got it all together and grill is good for another few years.

Perfect fit

Easy fitment, easy install