BlueStars 8540101 Washer Belt Standard Size 0.55 Inches Wide 48 Inches Long - Compatible with Whirpool & Kenmore Washers - Replaces AP6013037 8540348

My old belt wasn’t “bad” but it wasn’t great. It started to dry rot but wasn’t cracked yet. I was replacing shocks so decided to go ahead and replace the motor.This is pretty difficult to get on, be careful as it will snap off a few times and possibly pop your hand.The fitness was great, it stretched once it was on.The value is great, whirlpool OEM wants $50+!!The thickness is great, it’s thicker than the old belt that I had which was a replacement that was OEM.

I own a Whirlpool duet sport, WFW8300SW04. This is a perfect replacement belt. Honestly think it's better made than the original. Things to keep in mind- your original belt has stretched. The new belt will be smaller and therefore tighter. Place belt in lower grooved spindle (closer to the motor) then begin wrapping it up and over the larger wheel, slowly spinning larger wheel counterclockwise. It should snap on. I had to use 3 or four wire ties. I'd spin, wire tie, spin, wire tie, snip, spin etc. Eventually it popped on. 5 minute process max.

Worked great on my Whirlpool Duet washing machine. Was a little hard to put the belt on, but after some struggles it went on and has been working well.

Works with no problem

The belt on my Whirlpool Duet Sport broke and this is a perfect fit. Installing it takes a bit of force as the new belt is tight (as it is supposed to be). However, with a little bit help from a zip-tie (watch your fingers) it went on. Washer is working perfectly again.

Worked as it should

Perfect fit for my front load washer and not too bad to install either. Solved no agitation and no spin condition. Wife even thinks the washer runs more balanced due to the shredded belt no catching. I know it is quieter than it has been for a long time.

Side by side comparison of original part and this part. This belt is wider. It's 1/3 inch shorter, cannot reach the motor hub. See picutres.

I replaced the belt on my old Whirlpool duet sport washer. Was fairly easy to install on motor first then on drum by rotating the drum while holding the edge of the belt to keep it from slipping off the drum until the belt was positioned in the middle of the drum pulley. No problems so far.