Briggs & Stratton 692003 & 692011 KIT (Intake & Exhaust Push Rod Set)

Fit and works great

Excellent figment

Received and fit perfectly. Thanks

Perfect fit…. Right on time

the parts fit properly

Rods were a perfect fit.Super simple to replace. The engine I was working on was a 21HP Briggs, and it took a total of about 5 minutes, including resetting the valve lash.Uppn inspection, the exhaust rocker stud was backing out, and the aluminum rod was bent so bad the intake valve wouldn't even open. There was so much clearance on the exhaust valve rocker, the cap on the valve stem had fallen off and was sitting in the bottom on the intake!The process for replacement was simple. I removed both rockers and studs, 1 at a time so they didn't get mixed up, and applied thread lock to make sure neither one backs out again. Reinstalled the studs to torque specs, followed by new pushrods and the rocker arms.Set piston to TDC, adjusted the valve lash to what Briggs and Stratton recommends, torqued the locks to 60 in. pounds, reinstalled the valve cover with the recommended gasket maker RTV, and let it set up for a few hours.After starting and running the engine, I can't believe how much quieter it is, even at WOT! I guess between wear on the ends of the rods over the years, and the exhaust stud backing out it just got louder and louder over time. Checking that valve lash is something that I'll do every other year because I didn't realize how big of a difference it would make.

good replacement push rods

Seems to be working fine so far.