Saddlebag Tail Light Smoke Lens

It’s great, 10 minutes install, plug and play, wiring length perfect hope durability is good

Not sure why some reviewers are having so many issues with electrical problems and everything else. I had these installed in under 10 minutes (not counting the time of routing wires to my liking). I have an all but stock 2023 Harley-Davidson Ultra Limited and the fitment and connections were perfect. I did not even have to take the saddlebags off. Step 1 - Remove seat and connect to your tour pack light harness to test functionality and to get the left and right signals correctly oriented Step 2 - Clean the area you are mounting the lights to Step 3 - Peel off red tape to expose the sticky film Step 4 - Mount the lights to the appropriate side (I placed mine a couple millimeters under the lip of the saddlebag lid) Step 5 - Route wires to your liking and use the supplied sticky squares (I simply used zip ties) Step 6 - Test functionality again It was really that easy. No check engine lights, no electrical lights on my dash. Right, left and 4 ways all worked flawlessly. I closed my garage door and waited until it got a little darker and tested again. These are significantly brighter than I imagined and the flow sequence is a nice, attention-grabbing plus.

These installed easily and work very well. Obviously, over time I will need to amend this review with an update in a year or so, but as of now, the saddlebag lights are 5 star, at this price they are 7 star. Watch a couple install vids and pay Attention to cable routing.

Very bright and easy to install

They look good and they work good too.

Great addition to my Harley installed on 2025 road glide and everything works perfect

Tried 3 sets of these baglights and all were junk. First set wasnt even the right plug for my bike as advertised, and found out many had this same issue. Ordered a different set with right plug but they didnt work so they sent another set and they dont work either. Checked with a testlight and had power but light is junk. Worst part i have to return to UPS store thats 30 miles away and pay $3 for return label. Each time! Wtf! Dont waste your time with these lights if you have a Harley thats 13 and older. Total waste of time and money. If i could rate it 0 star i would have!

Easy install. It will make removing saddle bags and bit complicated, but worth the trouble for the extra lighting in the back.

buen producto, quedo muy bien en mi moto, llego mas rápido de lo esperado, muy recomendable.

Can't go wrong for the price

Even tho not installed on a harley they were easy to install and mount. Looks great nice and bright

price and quality is seems great, plug and play for wiring. there were clip holders but no zip ties to hold the wiring. but i had my own. functionality looks great, i installed it yesterday may 16,2025 lets see how long they will last.

These lights are very well built for the price and function extremely well. Installed on a 2025 Road Glide CVO/ST in less than 30 minutes. Completely plug and play. You just remove the saddlebags side panels and seat. Compliments the back of the bike, very bright and they look factory. NOTES - Make sure you clean the mounting surface on the saddlebags with rubbing alcohol and warm up (hair dryer warm, not hot) the adhesive tape and the saddlebag mounting surface before install as it GREATLY IMPROVES the ability of the tape to hold. Only complaint is that you need to take off the seat to remove saddlebags after install as the wiring connectors are under the seat. I resolved this by adding another set of connectors but relocation of the connectors at the factory would eliminate having to remove the seat.