Milwaukee Airless/Finish Paint Sprayer M4910-21

I am an amateur and maybe did something wrong but this ended up at the junkyard after a couple weeks of frustration.Clogged after first five minutes of using. I had followed the directions carefully and purchased the correct tip and had strained the paint.Milwaukee was horrible all they did was read the instruction manual which I had memorized by the time I contacted them. The. They then sent me to a repair shop when I arrived I realized it was a residence and knocked on the door and the new owner told me that the man who used to do repairs had died.After that they refused to refund my money as did the company I purchased it from.

se rompio en la cuarta ves que la huse me vecino compro una y tambien se dano tiene algun defecto en la bomba el motor 100% bueno

the tip guard gave out after 1/2 hour. so the job i was working on that should've been 2 hours took 6 hours. because of the malfunction, time lost, money lost. Fife, the company that sold me the machine wrote me back asap, stating that they are going to send a replacement. if it wasn't for this matter of the tip guard (the part that screws to the end of the gun and the spray tip inserts in) i would of gave 5 stars. everything else about the machine is good quality. the tips are not that great, but i knew that when i bought the item. for the price it can't be beat. at worst ill buy a graco tip guard.another 25 bucks...UPDATE:i was sent a new gun. this one too went bad. so now i have to replace it with a new gun, another 100 bucks.should have just gone with the graco.

This sprayer works well. If you are painting fence or general latex it will work fine. The nozzles than come with it are just ok. I wanted to spray clear water based polyurethane and it didn't do a good job of atomizing the spray. However I went to lowes and bought a Grayco 4/11 spray tip (it fits perfect) and that turned the sprayer into a real machine. Now I can spray with beautiful results. So figure on spending the extra $25 or so on a Grayco spray tip if you buy this machine.

this is a beast. directions have a little to be desired, but the product works great. used it to prime a room and paint the ceiling before rolling the walls. had a little issue with the tips, but i i think it i would have taken my time to work out the correct pressure they would have sprayed fine. i have read a lot of people just junk the tips that come with it a purchase new ones. i dont plan on doing that until i test them again on my next project.cleanup is supper easy. just attach to the hose and run a couple gallons of water through it.

Set up is a little involved but once it's working right it covers a lot of area very quickly. Not good for fine work there is a lot of over spray. Had two problems with it first the trigger would get stuck and the paint would keep spraying until the machine was turned off. The second problem is the prime would not function correctly had to stop the job.

This machine is supposed to be able to spray large areas as well as being used for fine finishes. It was great for the large areas. Did an excellent jjob.I question how it can be used for the fine finish of moldings and doors. This is a heavy duty machine. Not sure if you could use it with a gallon pail. It is time consuming to clean. Not worth the effort unless you have a lot of painting to do at once. However I more than got my money's worth for the large area coverage.

Very nice machine. I brought this sprayer to do a few houses that I have to paint. You are limited as far as extentions for the gun, I haven't found one to fit it yet. The 310 tip has been giving me problems so I'll replace it. Everything else works great.