Confectionery Funnel, Stainless Steel Funnel with Stand and 3 Nozzles Commercial Grade Cake Decorating Tool Batter Funnels Precise Dispensing and Filling for Home Kitchen, Cake Cupcake Baked Use

Although it looked pristine, i gave it a thorough cleaning, adjusted the plunger and went straight to work. I had to pull out extra molds on top of tge e tras I had already prepared. Theres is virtually zero mess ehivh means it all goes into what youre making. I was able to work so fast that I even emptied the the firat batch then emptied pot. If youre considering this for personal or business use, get it, you wont lose any of your product through cooling and bad pouring. Best of all, you wont look back, but to laugh at how you used to do it.TIP: ADJUSTING THE PLUNGER1. Tighten plunger screw until it just barely stops.2. Tighten crossbar(that holds plunger) until just barely tight.3. Fill with enough water to see of any leaks out past the plunger4. If any water leaks or drips, slowly loosen the crossbar until it stops.5. The plunger can now be loosened, if desired, for comfort

This funnel makes it easier and a bit cleaner to fill hot sauce bottles. The dislikes I have is it does leak, the hot sauce get stuck, and the funnel leans to one side in the stand so it falls over at times.

Great for tinctures and oils, my new favorite way to fill up containers.

My issue with this is essentially that the bottom of the interior (the hole that the stopper rod plugs to stop the flow) is a separate piece. Which in itself isn't necessarily a problem, except the rubber gasket that it comes with to create a seal is slightly too big. This causes the piece to not sit flush with the sides, which in turn causes the stopper rod to occasionally catch on the lip and not close properly. This, again, only happens because the hole that the stopper bar runs through at the top is so big that it doesn't keep the bar in a straight line up and down, so it kicks out towards the sides of the funnel when you press the button to lift the bar.I've used pliers to tighten the piece as much as possible and it's better, to where the rod only catches 1-2% of the time. But for a piece of equipment whose entire reason for existence is precision, 1-2% failure is still pretty high. And even then, because it's still not completely flush, to properly clean it I'll need to use tools to undo it every time which is obviously not ideal. I may try to find a thinner gasket at a hardware store and see if that helps.Overall, it eventually works decently enough, for the price, but only after some serious putzing around and possibly replacing some parts.

Ok so if you are looking to buy something for mayo or baking goods this is not for you, I've try mostly everything and the thick bathers won't go through the tunnel.

on top of it being absolutely FILTHY, there is a splotchy film on it that does not wash off.it is supposed to have three different size nozzles, however the only nozzle that fits is the one that came on it, the other two ( floating loose in the box) and do not fit at all - looking at the threads you can really tell why. the parts do not fit together cleanly because there are a ton of sharp metal flashing bits from manufacture that were not cleaned or ground off.it is not sturdy in your hand. FYI this thing is literally a foot tall.do not waste your money. if i could give this item zero stars, i would.

The media could not be loaded. Visually it seems like it should all work. No directions and the handle is not working properly. Doesn’t sit properly in stand which is dangerous when using hot products

Me gustó bastante, de buen material, se atora poquito pero creo que es porque está nuevo