Black 7" Inch LED Headlight with DRL+ 2x 4.5" 30w Fog Light Passing Lamps Compatible with Motorcycles

Better than advertised. Very happy with this purchase. Came neatly packaged, very sturdy looking product, clean and clear, does not look cheap whatsoever. Install on a 13 Ultra Limited. Probably should have bought the adapter ring for the headlight but I wanted to finish my project so I made my own and cut back of the bowl out of the stock bucket. So unless you have sheet metal shears get the adapter. No adapters are needed for the spot lamps. If you want all the extra features to work you will need to do some minor wiring to your turn signal leads, aux leads, etc. Install time for me was about 1.5 hours and I do my own work on the bike. These are every bit as bright as stock if not brighter, cover more area and the halos draw extra attention. The LEDs are very bright and cast a white/blue light, very effective at night, especially with reflectors and animal eyes. The built in turn signals are bright enough to use alone with the spots off but with the spots on they are drowned out slightly as you can see in the pics. With the extra features ( Halos and turn signals ) I would buy these every time over the ones from the Harley stealer ( 450 Bucks ). I attached some pics so you can see a full install, I could not find pics when I was shopping which made me hesitate but Im glad I grabbed them.

These lights are bright and look awesome! Here's a quick run down of what I did since theres no directions. The head lamp itself I didnt have to do any modifications other than buy the mounting bracket. The fog lights did however required a little more work. Fist off they didnt fit in the light housing like they should. I solved this by eliminating the thin bracket on the stock lights and went to the store and bought some foam weather stripping in a roll ($2.99) and wrapped it around the light for a tight fit. As for the wiring, the fog lights come with an adapter that should just hook up to the stock adapters which will give you just white lights. There will be two extra wires aside from the adapter (blue and yellow) which are for the demon eye effect. So to get these to work I extended the wires by 15" or so and drilled some holes in the light housing in a place that wasnt noticable. At this point you can either run these wires to an alternative power source or do what I did and run them to the extra wiring located on the headlamp wiring harness (see the picture with arrow). Took me about 4 hours to install just one fog light, but once I knew what I was doing I had the second headlamp done in about 20 minutes.

These lights are amazing for the price!!! Would've given 5 stars, but super vague instructions for the wiring install, and the spots don't fit my '12 Ultra Classic correctly without modification. I had to use my die grinder with a roloc disk to grind about a 16th of an inch off of the backside of the outermost part of the spots. As for the wiring, the halos were all plug and play on mine, but had to hard wire the signals. The best way was to pull a wire through the wire sleeve with the rest of the factory wires, up to the connector in the fairing and then splice it up there!!

This has been one of the most satisfying purchase I've made. This lights are plug and play at least on my 2000 Harley Davidson Heritage Softail FLSTC they look like a million bucks. I did not hooked up the demon or the flasher just because is not what I was looking to do. They are very bright and it gives the bike an awesome look. As far as durability I couldn't say I just installed them today 6/23/2017 but I will be back and post it again in a few months. Nice lights I will recommend them just for how they look on the bike.

Extremely nice look on my bike. Very easy install for plug and play, but if you are planning on wiring turn signals, etc.....do not count on instructions, the poorest I have seen I think. Light works great, very visible, and easy installation. I was glad i read reviews first which mentioned getting 7" round mounting bracket. On a 2010 Road King Classic, definitely needed, but even that is an easy installation and switch from standard Harley Davidson mount. Definitely worth the money, and a much better solution than the "name" brand pricing.

I love these lights. Not the easiest to install but if you take your time anyone can do it. I have a 2016 Ultra limited. I drilled small holes in the passing light housing to route the wires. They make rubber grommets for the holes. I put shrink tubing around the wires to make it look professional. I also removed my fairing so I could route the wires properly. I used the cigarette lighter power for the DRL's on the passing lamps and tied in the turn signal near each harness connection. I did not connect the DRL or the turn signal on the headlamp. (I am not even sure what they will do on the headlamp? Anyone?) I guess my biggest concern is the Headlamp chrome ring does not fit as tight as it did with the original headlight mounting ring. I may have to revisit that. These lights are well worth the money and the Demon eyes are a distinct look from other bikes.

I didn’t have these lights a couple months and the right fog lamp already has moisture inside the lens. Very disappointed(Update)After a couple more days the halo ring in the right light and blinker function quit working all together. Product does not last!!!!!