EKWB EK-Quantum Vector Red Devil RX 6800/6900 GPU Water Block, D-RGB, Nickel/Plexi

The media could not be loaded. I can't say enough about these solid, heavy waterblocks from EK. First, my OC'd 3090 FTW3 never breaks 42C, and now my OC'd 2750 MHz 6900XT never goes above 44C. Ridiculously easy to install since the block is milled to the right depths above each chip. All you have to do is clean off the old pads, cut up the included 1mm thermal pad material, and copy the diagram for which chips to cover. Then take the protective film off both sides of the thermal pads, spread the include Thermal Grizzly (included, NICE!) thermal paste on the GPU, set the block in place and snug the included screws a little at a time. Looks great, too. Buy it.

Bought it about two months ago. Been using Ekwb products on last two builts. Never disappoint and always have concised instructions. Although you have to look it up on their website, and I understand of saving the environment from all these used once manual.Great cooling and of course quiet and less coilwines, for some reason. Highly recommended if you're on the red camp.

The media could not be loaded. Works amazingly before I had it my GPU would overheat very fast. GPU running at 100% and doesn’t get any hotter than 70° Celsius which is amazing. So my only issue with it is that it’s made out of cheap plastic you need to be careful not to over tighten any of the screws like the one that connects to the hoses if you tighten it too tight you can strip it and the screws that are connected to the water black when you need to clean it make sure to not over tighten the screws because your crack the water block

The media could not be loaded. I really recommend it, EK Vector Red,If you want to see the full video go to Dj Maury Podcast on YouTube