Amazon Basics 3D Printer Filament, 1.75 mm, 1 kg Spool (2.2 lbs), Silk Off White

Not TPU more like PLA I was after TPU, prints well and looks nice, so yes I will buy more. I printed on E3D-V2.

I was not expecting the best with it being an Amazon Basic pack but how surprised was I.I absolutely love this stuff and have yet to run into any problems with it. (That is probably the kiss of death on them now)I will most definitely be buying again in the future.

I was not expecting the best with it being an Amazon Basic pack but how surprised was I.I absolutely love this stuff and have yet to run into any problems with it. (That is probably the kiss of death on them now)I will most definitely be buying again in the future.

It's a nice, solid PLA....but it's not very silver. It has a slight grey / beige hint to it, so it looks more like a dirty silver (?) than a nice radiant silver as one would hope.

First Impressions - was concerned at the start of the print due to the very strong stringing even at 190C and some lumps of filament on the strings, but the print didn't fail though.1. Product title properties saying PLA, while product description ( with nice marketing images ) says TPU. I am confused.2. Just tried to print stringing test and it looked terrible with very brittle spikes.3. Set another print see bad stringing and underextrusion.Before that was using an alternative filament for the same price and had no issues 😕

I really like this filament, hardly any printer tuning required, little to no stringing and the colour is a really nice quality. Would definitely order Amazon filament again :)

This was my 1st spool I bought after using some of the free sample included with my 3d printer.I found the adhesion to be slightly inferior that what i had previously used.I adjusted a few settings ( lowered the Z axis) and heated the print bed a little more and it all seems to wok perfectly.It might be worth keeping note on every brand of filament so you can fine tune it next time you use it.I did find it was wound slightly badly and got tangled at 1st, but that soon cleared up.The Silver is a great finish and colour. I've had not blockages so far and I'm about half way thru.Like I say, my only note would be to keep the temperature nice and warm when using.

Prints well enough. Seems a little stringier than some, probably my settings (new to 3d printing), perhaps I let it get damp. Nice colour, good layer adhesion.