Material: Pigment Color: 15 colors Volume: 10 ML/each Note: 1. Please shake well before using. 2. Please wear gloves and protective clothing before using to avoid direct skin contact and maintain indoor ventilation.
B**Y
Brilliant value!
Great product and is clear. Few bubbles after mixing but seems to settle really well and stays glossy. Cures well and within 24hours it can be taken out of a mold. Kit that’s comes with it is really great and some handy item to keep in your arsenal of products you can use. Will be buying again.
K**R
Not a bad resin for crafts
Easy to use 1:1 ratio.Made some lovely items put of this resin.. however I do find it creates a lot of bubbles... add heat,and it does help draw them out... but have had a few items where it's been hard to get them out and seems to be more than with my last dif. Type of resin.Will buy again though ad a good price and I think spend longer warming resin in sections to entice more bubbles out. But made a lovely phone holder no problem... colours mix well with it, and it sets fine.. maybe takes a bit longer to be fully rock hard set with no give, but overall good resin for crafts etc.
A**R
Instructions poor
arrived early , instructions are poor , my first attempt at small moulds were sticky and soft after 24 hours , second attempt was perfect . you have to be very careful to make sure you add the exact amounts and a few drops more of the hardener , you must stir for at least four minutes , i suggest you put better instructions , as the bad reviews are mainly due to the poor instructions , there was no leakage on mine and they were sealed under the caps . i will buy this again .
N**S
Inconsistent product supplied.
2nd purchase of product. Initial purchase of exactly the same listing included mixing tools and gloves. This is received did not. Was a gift as a started kit as the 1st purchase was so great. Disappointing quality and product is not consistent.
R**N
Excellent Product
Used to make large heart shaped photos.If resin and hardener pour slow,set them in a bowl of 50 degree C water for a while.This will not only make them flow better but will lower the final setting time of mold release. When mixing the Resin and Hardener,don't stir too vigorously and there will be very few bubbles.Found to be an Excellent Product.
ترست بايلوت
منذ شهرين
منذ 3 أسابيع