Creality 3D Printer Stepper Motor 42-34, 2 Phases 0.8A 1.8 Degrees 0.4 N.M 42-34 Stepper Motor for Creality Ender-3 X/Y/Z Axis and CR-10 Series Z Axis

Good quality material. Works as it was made too. Would purchase again.

Was having issues with my z axis. Turns out the original motor was weak. Replaced it and now I'm back in action.

ordered it thinking i needed to replace one but was able to correct the issue without using it have a spare now

Definitely works as intended, drop in replacements for my Creality CR10S5.

I bought 4 steppers for replacing my old steppers, I had one stepper dead on arrival, it would overheat beyond touch-ability immediately, regardless of voltage applied. (It would start low-voltage skipping and still be super hot.) Amazon was nice enough to send a replacement really fast, and after the swap, I could send back the old stepper motor, well played Amazon. Well Played.

The media could not be loaded. Got this as a backup for my 3D printer, or perhaps a future photography project. It passed the usual bench tests so there is not much more to say. This is just the bare stepper, no cable or mounting hardware/fasteners. Reasonably priced, I see no reason I won't buy more of these as the need arises.

I picked this up as a backup and replacement for my Ender 5 Pro and Ender 3 v2. Creality uses the same steppers for most all printers which makes this a drop-in replacement should one of the motors go bad or begin showing signs of failure.In testing the motor on a backup Creality board, it functioned as expected.It's difficult to truly review a stepper motor as it either works or doesn't. Creality has a pretty good track record with their steppers in my experience, so it's great to see the motor works and that it'll be ready when it's needed.

I like to have spare parts on hand. This is the perfect size for my Ender 3. I now have my Ender 3 converted to direct drive using the OME parts. This will match the X, Y or Z motor.