Edge Supply Red Oak 3/4 inch X 50 ft Roll of Plywood Edge Banding – Pre-glued Real Wood Veneer Edging – Flexible Veneer Edging – Easy Application Iron-on Edge Banding for Furniture – Made in USA

This edging worked great on the island we built. It stained nicely, sealed really well and put the perfect finishing touch on the top!

Easy to install and stain. Looks great!

Great adhesion when properly applied and perfect color match to the red oak ply I bought at our local lumber store. Made custom built in bookshelves.Only complaint is the branding sticker used leaves a sticky residue that stains the wood. I had to cut off about six inches and toss off the beginning of the roll and it just happened that I was short that amount for my project.

Have purchased this multiple times. Works very well. Will continue to purchase as long as they don't hike the price up.

I loved this edge banding. I applied it with an iron and pressed it down with a wood block. I didn’t have any issues with it lifting or with the glue coming off. It was just slightly wider than my 3/4 in plywood which was nice because that made it easier to apply. I trimmed the excess with a utility blade. I went nice and slow and had no problems. It stained well and matched my plywood perfectly. Highly recommend

This is a little thinner that the Band-It brand stuff I usually get. It also required a little more attention during installation to make sure the glue was thoroughly melted and adhering well. Ultimately, it worked fine, but I will probably go back to my usual brand next time.

Sized just a hair above 3/4” plywood (which isn’t a true 3/4”). Very little trimming necessary…a big plus! Spliced seams nearly seamless…haven’t started staining, yet. Plenty of adhesive to adhere properly. I lightly sanded/wiped the ply to level rough cuts between ply’s b4 applying edging. Lightly sanded edges at 15* in both directions with 120 to avoid any potential tear out, then at 45* to meld edging & plywood with 150 sand paper.

It's extremely brittle. have to be very careful when applying it.

EASY TO INSTALL AND TO TRIM. YOU CAN'T ASK FOR MORE. I used Birchwood Casey Tru-Oil gun stock finish on it because you can apply it with your finger so it is not messy. You could use any clear product on it.I just happened to have the stock finish already. Real nice.

Seeing that I am from Australia and the edging comes from the US, it matched the Red Oak plywood perfectly.