Amana Tool49493 - 49492 Carbide Tipped Corner Round 1/16 Radius x 5/8 Dia x 5/16 x 1/4" Sha

I love Amana Tool bits. They are strong and last a long time. This one is no exception and gives me that wonderful 1/16" round-over I was looking for on some wall sconces that I am fabricating. I used this to put a 1/16" round edge on 12" x 4" x 1/4" beech wood planks as a base for my sconces. In my opinion, the 1/16" uniform route created by this tool looks way better than the other choices for this European Beech, such as 1/8" round-over or simply breaking the hard edge with sand paper. With the thinner 1/4" material, the edge created by this bit is definitely noticeable, if not preferred as previously mentioned. Shipping was fast, great price for this hard to find bit, created by a reputable and trust-worthy company. Almost every bit I own is made by Amana Tool, safe for one bit, my compression (up/down combination spiral) which is made by Align Carbide, simply because the Amana Tool compression bits are more than double the cost ranging from $50 USD all the way up to $200 USD for a single bit (depending on width, length, coating, and type of material you intend to cut).

This is being used on aluminum and it has no problems whatsoever. This thing is going to rock over the long term because of the 4 cutting edges and hi quality carbide

Amana router bits are my go to and this one was no exception. Performed perfectly for the application of creating a bullnose for stair treads. These are priced higher but worth it because the quality is high and longevity of the bit pays for itself.

Great micro round over, leaves great finish

never fails! love these router bits! Amana are the best for me so far never fails!

I usually buy Whiteside bits, but the Amana was either a better price or the Whiteside wasn't available, I don't remember which. The Amana is sharp and as well made as Whiteside as far as I can tell. Good bit that should last a long time.

Takes the edge off nicely

I used this bit to create a roundover on the edge of some oak furniture I am building. It did a decent job, but not as good as a similar cheaper Chinese bit, and not as good as a similar bit from Radian Tools. These alternatives did similar tasks without any burning, but this bit from Amana produced obvious burn marks any time the cut went across the grain. The alternatives avoided this. Perhaps it is an issue of sharpness.

He comprado otras marcas, economicas y esta fresa rebasa la calidad de ellas, viene empaquetadamuy bien, cuidando el filo, el empaque cuida el filo y que no se oxide. muy recomendable.

hardly bumped the bearing against some steel and it went flying, new bearings very expensive