ACDelco gm Genuine Parts 15113134 Transmission Mount

I’ve been almost exclusively using cheap Chinese parts to keep my 97 blazer going, and they’ve worked wonderfully so far, until the time came to replace the worn trans mount. I went through 3 of the cheap ones and I think they all came out of the same factory. they are all the wrong durometer, the rubber isolator seemed like hard plastic and caused excessive vibrations, the metal part were so thin and made of cheap casting one of them cracked and sheared in multiple spots just being torqued down to specs. This one is genuine gm part from the Canadian factory. No more vibrations. Amazon says it doesn’t fit my 1997 blazer, it fits 95-2002 s10/blazer/jimmy/bravada with the 4l60e and 4wd

with so many aftermarket mounts available that meet or exceed OEM and are available for under 20 dollars, you'd think that THE HARDWARE would be included :/ "OH WELL!"

This is simply the best trans mount you can get for this vehicle application. The aftermarket ones are junk. Nothing beats the original equipment. If you don’t want unwanted vibrations then this is the one to get for this vehicle.

Expensive for what it is, but you get what you pay for. I just replaced this mount with a new one after 250,000 miles on the old one. Both were made in Canada and I would buy again.

This part felt heavy and sturdy like the original did. Im confident that it will last many years. The quality is great conpared to a cheaper mount. Which is why i chose this over a cheaper one. So if your planning in keeping your vehicles for a long time then this is the way to go altho it is a bit pricier but you ro get what you pay for and it is quality in this case.