EASON Stepper Motor Driver TB6600 4A DC9-42V 32 Subdivision for Nema 17, 23 Series Stepper Motor CNC Controller Single Axis Hybrid MicroStepping

This works very well. Pay close attention to the manual as it is important to get all the inputs correct to get the system to work. The connections are robust and easy to use. The system works very well and does not get hot even while driving a motor with the maximum current allowed.

Worked way better than the transistor setup I was using to drive a stepper before. Just so you know, there's ZERO documentation in the box- you just get the device and not a single scrap of paper comes with it. Use the documentation on this page AND note that for the dip switches the ON direction is down.Only thing they were really missing was how long you need to make the pulse on the pulse pins, or how much time you need on the enable or direction pins before the changes take effect. I used 30 microseconds on the pulse pins and it doesn't seem to miss any steps. Maybe less is fine, but that worked for me and I didn't need it to be faster so I left it at that.

Works well, and good documentation out there. Got ahold of it and working within an hour.

Exactly what I needed. Arrived quickly and efficiently! Thanks!

Product received different from images and description (advertised) . What I received was a DM542 driver (see picture). The drive current selection is different than advertised, and worse yet the pulses per rev (microstepping) are different than advertised, and for a 200 steps per rev motor you can't do full stepper control. The best you can do is 1/2 steps (setting of 400 steps/rev). The input voltage of part received is apparently 20-50vDc, which again is different than advertised. No documentation included, and I was not able to get a motor running properly above about 1500 pulses/second, so if you need to run a motor fast, this might not be for you. Who knows what you may get though. Beware!

Uses it on Cnc to pair with a same power rated driver . It keeps losing steps . Has to use it at a single driver situation

Great little stepper driver. I love the fact that this one runs the motor and logic at the same voltage (many others limit logic to 5V, which is not common in industrial applications - 24V is the standard!Device works great, but there are no instructions provided with it. What's more, other users have shown pictures for wiring which are good, but they have different graphics on the body of the part. So, that's a little disappointing, but I know enough to get through it.The other problem is that the ENA signal shows that it needs a voltage (the icon implies that there is an opto-isolator so you need to provide voltage to light it up. Unfortunately, the ENA label is misleading - powering this line will DISABLE the motor, not ENAble it. Ideally, the ENA should be !ENA or ENA with the bar over it... it's a negative signal. This means you can leave it disconnected and the motor will work fine...I asked the seller about this, and they were very helpful, so that was refreshing. I suggested they should update the ENA label, so we'll see if that happens or not.The rest is great - all works well for my small motor, so I'm happy. I took a star off for the mislabeled input and lack of instructions. Take a look at the instructions provided by other users, and just be aware that the ENA is backwards... and you should be all set!

Ready to setup. Works great!