Kuryakyn6227 Premium Iso Handlebar Grips For Electronic Throttle Control: 2014-19 Harley-Davidson Motorcycles, Chrome, 1 Pair

Once again great aftermarket from Kuryakyn, fits my 2012 FLHTC very nicely. Was very easy to install.

finition parfaite

So the grips look fine. Throttle side (throttle by wire) went on easy. However the clutch side was a nightmare. They send you the worlds most powerful super glue. It says in the directions that the glue sets up almost instantly, and you should be quick to slide it on. Ok well I slid it on as fast as I could and it started sticking about half way onto the bar. And on my fxbb there’s a little cut out that you need to slide the end of the grip onto. Well that didn’t happen. I ended up with a grip that was half way glued on. So I couldn’t pull the grip back off. I tore the trying to get it off. I was able to pull the metal part off and slowly cut the rubber piece off with an exacto knife. I ended up gluing the grip back together, putting it in the metal part and used spray paint to slide it into place. I’ve always used spray paint (clear) when installing grips and never had a problem. I should have this time from the start. My advice is DO NOT USE THE SUPPLIED GLUE! And FYI, I followed the directions to a “T”. I sanded the bar end and cleaned it with an ammonia based cleaner, per the directions.

I recently sold my Fatboy and stepped up to a Ultra Limited. The stock grips were very narrow and my hands started to hurt when I rode. I've ran these grips on my previous 2 softails and went with them again on my Ultra. Huge change in comfort. This bike is a '18 with throttle by wire vs my past cable throttle bikes. Fitment was great and went on with ease. I use dry graphite powder for the throttle side on the bar surface itself. the clutch side grip I refuse to use the supplied super glue. I use an old dirtbike trick and spray the bar down heavily with high hold hair spray then slide your grip on and position it. Then give it a good 30 minutes to dry and I've never had a grip go loose on me.

I had the same set of grips in chrome on my previous bike. I just bought a 2019 Harley-Davidson Softail Heritage Classic 114, which is mostly blacked out. The Iso Grips with a Throttle Boss was the first mod I did on my new bike. They look AWESOME and help dampen vibrations and reduce riding fatigue. I primarily use the heel of my right hand for throttle control and only wrap the ring and pinky fingers around the grip, which allows me to ride with the index and middle fingers covering the brake lever. Since I'm not having to squeeze the grip my hand never gets tired, even on long rides. I highly recommend these grips and especially this Throttle Boss.