Stainless Steel Magnetic Bit Holder, 3 Inch Length, 1/4" Hex Shank, Magnetic Tip and Hardened Shaft, Impact Tough Quick Change Screw Holder (Pack of 3)- By RamPro

I am super pleased with these Bit holders because I have been trying many different brands and I know I have finally found a long lasting bit holder that is very strong. I am a professional electrician. I use extension bits every single day with my impact gun. I not only use the bit holder for phillips screwdriver bits, but to hold magnetic sockets. screwdriver bits are light duty in my opinion. When using sockets to tighten nuts onto bolts, that is a more heavy duty use. Dewalt use to make a holder that was super heavy duty. I don't know what happened but they are all made of aluminum that does not stand up to heavy duty use at all. I have tried too many brands to mention. There are some pretty good ones like Milwaukee but the cost is 4 times of these bits and even those do not last as long as these. I bought 12 of these and I am still using the First one after a whole month , which may not seem like a long time to you, but believe me when I tell you a Dewalt aluminum bit holder will not last me two hours. I have had not issues with the magnet not holding any of my bits. I would highly recommend this product to anyone.

The pictures show one solid milled peice of stainless steel. This product is not one peice, but two separate pieces. When these low quality double segment peices spin in a drill, they tend to wobble. Wobbling cause me problems. The only reason I purchased was because they were advertised as a solid milled peice which solves the wobble problem caused by double peices not being perfectly lined up.

The reason for 2 stars is because the picture shows a 1 piece machined bit holder and I got a 2 piece bit holder that is pressed together. I dont like this style because they tend to strip out. I specifically bought this one because it shows it as 1 solid piece

Bought as a alternative to the bigger brands. This guy, under moderate torque with an impact gun, twisted and failed. All three. Then I changed to a yellow branded one I've had for years, worked no problem. Stainless steel is too weak for the job, period. Bad purchase.

Description states “The retaining ring ensures an optimum fit of the tool in the holder”There is no retaining ring inside the bit-receiving end of these shafts. The only thing that retains the bit insert is the magnet itself.

Solid bit holder. These are a big difference from the others I've used. Good magnet and sturdy not wobbly.

I liked the quality. But doesn't work as expected. The bit comes out consistently which makes it no good for construction use where it's used all day. Maybe good for home use.

Very happy with these bit holders. Some I've had the wire ring inside that held the bit so tight it required pliers to get it out. These are great quality.