Rectorseal 84016 3.5-Inch Wall Inlet, White

Great product fast shipping will buy from this seller again.

I used this along with other lineset cover ‘parts’ I had left over from installing 6 mini splits and it worked great, just measure the width of what you’re matching this up to and it works great without buying another costly line set kit.

Did what I needed

Installed it over Vinyl siding which was not an easy task. Flange holes are only slightly outside of the thimble so not a lot of room to get mounting screws in. Not really suited for vinyl siding so it sits at an angle. Still it is better than just a hole the wall. The good thing is it does come apart so you can install it after the line-set has been installed.

Like many others are saying, this was very difficult to secure on the siding. It took some finagling with some rubber bushings to get it to seat correctly and securely and look nice. Once it was attached it works great and looks nice.

The exterior wall connector is not designed well to be sealed to siding that has any pattern or texture to it while still being easy to disassemble. It seems like a design fault. Otherwise this system works well at a lower cost than the Mitsubishi line hides.

Easy to install, paintable

I don’t see how this could fit any hvac tubing going into your home. It’s too small.

I used this for heat pump pipe covering outside the wall. Looks good but pricy.

I bought the 3.5” duct kit to cover my lineset on a 24000 btu mini split . I needed one extra wall inlet so purchased separately . Matched and work perfectly. Looks nice and tidy !

No screws provided

Conforme à ce que j'ai commander, bonne qualité, bon prix

Did exactly what it said it would thank you