Blauberg UKLine E Low Profile Slimline - 6" 150 mm Extractor Fan for Bathroom or Kitchen with Humidity Sensor

Windows don’t even steam up now when shower is on. Only downside is it’s quite loud.

It is less noisy than the previous extractor I had. You can adjust the level of time the extractor works after you switch off the light, and the level of humidity, by turning the respective screws that are revealed if you move the plastic cover in the middle of the fan. The fan operates automatically every time I take a hot shower and reduces the humidity as designed. The quality of plastic and the fan is good.

Works well despite being cheap. Had problem with mould in the bathroom. Since installed it had reduce the level significantly. Easy to install but will recommend an electrician to do the install.

Good product. Does need to be setup with humidity sensor as to low and comes on in middle of night. Now sorted. Works as should.

Not as described poor customer service

Fast delivery, excellent quality product.

On opening the box, I was surprised to find that the instruction booklet was all in German! The product should NOT be sold in the UK without English instructions, although they can be found online. Assuming one does have the instructions, care should be taken with setting-up or the fan will not work properly and may stay on almost permanently.The fan can be wired directly into a live lighting circuit or other supply (fused 6A max) if only required to respond to humidity. An external override switch with its switched live connection to fan is not essential and is really only needed if it is necessary to remove smells etc independently of humidity.After installation and connection, it is best to set the timer to minimum and the humidity to maximum, and then carefully reduce the humidity setting until the fan just starts. It should then switch off after a few minutes when the humidity has reduced a little. It is probably best to keep the humidity setting towards the maximum or it will likely be triggered by ambient humidity rather than that from use of a shower or bath. The timer setting is a matter of choice: a 15 or 20-minute run-on after humidity reduces is generally adequate.

This is an efficient fan, easy to install although the instructions could be a little easier to follow. I fitted it in the ceiling and the noise level is quite high - much more than the previous fans which I have fitted. I guess that it will be quieter when fitted in a wall.