Weatherproof ABS Solar Double Cable Entry Gland for All Cable Types 2mm² to 6mm² for Solar Project on Rv, Campervan, Boat

Very well built strong plastic works as it should. Reasonable shipping time yes I would recommend this product for anyone looking for a good price on a product that will stop rain or snow from entering your home or rv

Worked great on the roof of my RV. Half the size of the OEM one installed on the other side. Was able to fit 8awg wire through the connectors without issue.Started installation by removing a recessed light in the bedroom that was 8 inches from a wall. Lights just release and hang; they are held in with 2 spring clips. Reached in with my hand and felt a plastic vent pipe going to through the wall to the roof. Went on the roof and drilled a 1/2 inch hole down through the roof and through the 2x2 stud going across the wall. Ran 2 8awg wires down and pulled them out through a small hole I made in the wall under the sink.Ended up ripping the whole thing apart and made the hole 1 1/4 inch to be able to use this wall as a chase.Unit installed on the roof with butyl tape and Dicor. Fastened it with 4 screws. Looks great.

Easy to install. When using it to go through metal, trim the metal so it doesn't come in contact with your wires, or have the metal a 16th of an inch bigger than the opening. Low profile and has an angle area, if using on a vehicle or towed vehicle, place it so the angled part towards the front.

A good simple unit, with some nice touches and a couple of small issues.This ABS case is well designed, with the helpful touch of being sized to serve to keep the inner nuts from spinning (see photo 1). The 3mm (eighth inch) wall thickness makes it extremely sturdy.The two issues are: (1) one of the mold's injection points is very close to one edge, making that spot slightly less effective as a seal (but sealant compound or butyl tape will fill it nicely). (2) Lack of instructions left me guessing as to where the sealing gaskets on the M20M fittings should go: inside or outside? If outside (like the product photo shows), the gasket is distorted as it wraps around the shape of the box (see photo 2). Tightening the nut pulls it away from the threads on that side. Placing the gasket inside (photo 3) appears to create a good seal, but now the un-gasketed outer fitting has wicking opportunities for water, which could lead to problems during freeze/thaw cycles. Again, enthusiastic application of sealing compounds will be the probable solution.

Very nice. Feels like quality materials.Doesn’t have pre drilled holes for mounting which I suppose is good to let you decide where and how many mounting holes you want

Great product

The item are made from Excellent quality !!

Good quality