Lantsun® Black Steel Upper Windshield Mounting Brackets with A-Pillar Bracket for 52 Inch Light Bar Fit 97-06 Jeep Wrangler Tj / Lj(1 Pair) J134

Cheapest I could find online. If you look around there is another company that is similar price but with tons of bad reviews. Because they make theirs and weld it together. This one is not. It is a solid 1/8 inch piece of steel. It is not powder coated, it is a wrinkle paint. But in my opinion, it shouldn't matter for this unless you drive like a retard. The top notch on where the led light bar goes has an opening rather than a hole. It has 2 holes below it. IT works great, but I would have made that opening closed for more security. None the less. Its with 3/4 less the price of most other company and is solid product. Gets 5 stars for build and price.

Fit was great! Finish was a bit cheap and had to touch up with a little rustoleum.

Great mounts. I did have to ream the the pre drilled holes out to accommodate for the beveled heads on the factory screws. Otherwise the screws will not seat far enough into the windshield frame. I found after the fact that you can just order the longer tail gate screws that are an 1 1/2" to replace the 7/8" oem Torx screws. Still solid brackets and look great on the tj.

Nice and durable but the finish faded.

Don't buy these for your tj wrangler. They don't fit. They don't fit flush with the windshield and my light bar (correct size for the mounts obviously) had a lot of trouble being mounted as a result. Do yourself a favor and buy it somewhere else.

Horrible fit, screws that you remove from jeep are to small to remount with mounts. Also the inside edge is not serrated to hold light in place. it is smooth.Sending back..--UPDATE-I wanted to write that even though I was not happy because the time and work to put into my jeep and to see that the factory screws cant be used. Lantsun did respond promptly by email, concerned and haven't had the problem of the factory screw not being long enough. This concern and prompt response shows me they care about their product. I have already returned the mounts, but will be sending picture to them so that it may be corrected if needed. Changed star rating based on the service and concern.

awesome mounts, works with a 52" light measured from end to end. Sits the light bar almost higher than the roofline on my '05 Wrangler, will make your light bar whistle loudly with the top off.

Only reasoj its getting 4 stars and not 5 is because it requires you to go buy longer bolts, it does not state this. My thought is charge me an extra (insert dollor ammount here), and let me be able to just install it!