Cable Matters Infrared Remote Extender Cable - 25ft, IR Repeater Kit Cable, IR Extender, USB Infrared Remote Blaster Cord Up to 15ft Signal Range, NOT Compatible with RF Remote

Works perfectly!My wife bought a new gorgeous entertainment center but it has no glass doors or any other way to send an IR signal from the remote to the device when the doors are closed.This little product hooks up in seconds and does the trick! I have the receiver portion of this just barely peeking out from the corner of my center channel speaker that sits on top of the entertainment stand. The cord runs down the length of the speaker and behind the stand down into the stand where it points right at my AV receiver and my 4k player.One thing to note: this is not a programmable type device. It picks up ANY IR signal from ANY remote and transmits that signal to the other end. I did not realize this before I purchased this and actually ordered two of them thinking I’d need one for the AV receiver and one for my 4k player as they’re in the same cubby of the entertainment stand but on different shelves. Not so. Once I realized this I positioned the broadcast portion of the device on the inside of the door of the stand so that it can broadcast the remote’s signal to either device, depending on what remote I’m using. Ultimately I returned the unused second device and just kept the one.I sit about 12’ or so from the receiving end of the device and have had no issues whatsoever sending a signal to the device from my couch.Very cool little product that does exactly what you need it yo do. Highly recommended!

This will extend the range of your infrared remote control and allow you to control equipment (cable box, AV receiver, etc.) inside cabinets behind doors. This is the perfect inexpensive solution if your equipment is hidden or not in an easy line of sight of your remote control. You will need a power adapter (not included) to connect one end of the USB A cable for this to work. An old cell phone charger adapter works. You place the "receiver" which captures the signal from your remote control in a spot that you can easily point your remote at. Then you double sided tape the "transmitter" in front of the device you are trying to control. Typically the device has an infrared eye that a flashlight will help find. It's best to tape in front of this. The 'receiver' unit has small blue LEDs that flicker to let you know it is receiving a remote control signal. Sometimes it flickers because of random stray signals but doesn't affect its operation. The "receiver" and "transmitter" each have about 5 feet of wire so you can place them up to 10 feet apart. This works exactly as intended. A recommend buy!

Works great! Easy to install.

Works decently, not as receptive as the TV itself but I needed it because my soundbar blocks the TV’s receiver.Does not work well if inside a cubby, but I have it sitting right next to the soundbar on top of the TV stand. you don’t need to aim the remote directly at the receiver, but you have to aim in the general direction of the TV area, unlike with the TV’s receiver where i could point the remote basically anywhere.

6 foot version - review:I did not have line of sight to my DVD player with it's remote. I powered this device up, stuck the receiver higher up and the transmitter by the DVD player (which was low and behind furniture), pressed power on with the remote. The DVD player powered right up.The cables where plenty long enough to go where I needed them to get to.

For the unit I received, the IR receiver's signal range is approximately 2 feet. That does me absolutely no good sitting on my couch. While it was easy to install, and worked well if you're holding your remote right up to the receiver, at that range, it's effectively pointless to have. Based on the other positive reviews, perhaps I received a defective unit, but unfortunately that is my experience. I will be returning and trying another brand.TL;DR - Extremely limited range rendered the device unusable*. Returning. Would not recommend.

My equipment is out of sight, so the need to communicate to a devices inside cabinets was solved with this device

Got this device to put my Xbox out of sight into a cabinet. Everything works like it should. Obviously, the adhesive is terrible, just expect to come up with your own solution.More importantly, the advertised range of the receiver working for 15 feet from your remote is not accurate. Ours stopped working about 10 feet away. Which is unfortunate because our couch is roughly 11 feet away from where I wanted the receiver.Also, unless you're within a foot or two of the receiver, it won't detect a button hold (necessary to turn off an Xbox), but just registers it as a single press.I intend to return this and replace it a wireless IR blaster that advertises it works 30 feet away.