Pintech Percussion Drum Hoop Rubber Rim Trim (SILENTRIM16)

This head was purchased for backup purpose and I have not put in service at this time. Hoop ends appear to be cemented good and smooth. Looks very tough and appears to be made with quality.

Made from a high quality rubber that is easily trimmed to fit your drum. I used this on a DIY acoustic to electric snare conversion, and it dampens well enough to separately trigger rim and snare hits while keeping the noise down.

I was given a couple of snare drums recently when a friend moved, and the one pictured had rims that actually had the rolled edge toward the head so this would not work on that rim. I was fortunate that both snares were 10 lug so I swapped rims with the other snare and made it work, but look at your rim, if the top edge doesn't roll toward the outside as opposed the the head side I would reconsider. It did work well after the rim swap, but my 2nd snare is now useless as the rim swap only worked for one drum.

I was expecting a rim that was one whole rim and not separated. This rim is bigger than the size of the drum rim and requires cutting. Very disappointed but it functions well

This is an amazing product!! Get them while they have them in stock! These are for your acoustic drums that are converted to electronic drums. Great Quality too.

This rim guard fits well, thus protecting the rim and sticks . It is a bit wide on the outside so getting a drum key on the lugs is a bit difficult but not a deal breaker.

The title for this product is very misleading. It reads "Pintech Percussion SILENTRIM10 10" Electronic Drum Trigger". It is, in no way an "Electronic Drum Trigger". It is only a piece of rubber. There is nothing electronic about it.

This product pushes onto the rim very easily but is rock solid under impact. It took me about 3 minutes to dial in the adjustments with my Roland TD-11 to get a perfect rim shot. Great product!