Mud Flaps Kit for 2024 Volkswagen VW Jetta 2019-2023 Mud Splash Guard Front and Rear 4-PC Set by TOPGRIL

Nothing less than five stars. Installed on wife's new 2025 Jetta SE. Perfect fit and a lot less expensive than OEM option to be sure ( $148). Very satisfied with fit, form and material heavy duty, not cheap thin flimsy plastic. Very satisfied and highly recommend. Car looks a lot better too.

Great! Excellent value for the price. Easy to install and look good!

Perfect fit for a fraction of the cost of OEM mudflaps. I was able to install the front by turning the wheels. The rear required me to take the tires off. I use the small awl to punch a hole for the third screw and reuse the OEM screws for this on each of the four mudflaps

Installed on a 2023 Jetta. Fit and quality are good overall and the flaps seem durable. Overall better price than OEM and similar overall in look and feel. 4 stars given due to hardware provided (strips easily unless tire is removed especially on rear) and instructions that imply it can be done properly without removing rear wheels. Front wheels are simple when the wheel is turned to facilitate removal and installation. To install the rear flaps properly, the wheels should be removed first especially if using the hardware provided (strips easily). Removing the wheel also facilitates proper tightening with a proper tool (offset tool provided is not the best for tightening and also leads to stripping of the supplied cheaper Phillips screws in my opinion). If you use the hardware provided it: (1) strips easily due to the Phillips recess, (2) is oversize from the OEM hardware removed so if you install it and it strips, using the old hardware is somewhat loose so you may need to go buy new screws, (3) the screws provided have a green tint to them (vs black). I decided to reuse the OEM torx hardware after installing the first set. As long as you don’t install the provided oversize screws, the original removed screws will be tight when installing and can be tightened more easily without stripping (also it may be possible to install the rear flaps without removing the wheel if the OEM torx hardware is reused - they are easier to tighten and run with the offset tool provided). Also when installing the front flaps on a 2023 Jetta, the third hole towards the inside of the flap should be pilot drilled (using a smaller drill bit than the screw) as no hole exists at this location. Installing a fastener here greatly improves the installation and stability. I circled this location in the pictures and used the OEM fastener when installing (I installed this one first and used the provided hardware at the location). The hole can be drilled with the front wheels turned to provide space. For the drivers side, turn the wheel to the left - opposite for the passenger side. There is not enough hardware provided in the kit for this third forward location unless the OEM hardware is used here or reused at existing locations.Again after installing I find them to be durable and as good as the OEM flaps for less overall cost. Just be aware of the limitations/quality of the provided screws (consider reusing the torx screws removed at existing locations) and also consider removing the rear wheels to facilitate the installation.

Item was as promised. Got in a very timely manner and was well packaged.I am adding to this review several days after I made the first one.The splash guards fit my 2020 Jetta like a glove. Regarding the back ones...there was no drilling needed for new holes. The ones that came pre-drilled lined up with the ones on the car. The fit was flush...no gaps. Regarding the front ones. The only hole that I drilled in the plastic fender liner was for the hole in the splash guard that was at the inside of the fender liner. The ones along the edge of the splash guard, like the rear ones was spot on. The plastic tabs on the splash guards were perfect to the body of the car. Once all four were on...looks great.

Please be aware that this product does not fit a 2019 Volkswagen. Jetta, like it says, save your money. Do not buy plus the holes are not lined up.

Very pleased with how well these splash guards fit my 2024 Volkswagen Jetta SE. No one would ever know they’re not the original OEM. Very easy installation and didn’t even need to remove the rims.

Excelente producto