🔥 Elevate Your 3D Printing Game!
The T-D500 Thermistor is a high-performance temperature sensor designed for 3D printing enthusiasts. With a maximum temperature rating of 500℃, it is compatible with various hotend setups, including the PT100 V6 and Prusa i3 printers. Its cylindrical design and lightweight construction make it an ideal choice for precision printing with materials like PEI, PEEK, and carbon fiber.
| Manufacturer | POLISI3D |
| Part number | T-d500 |
| Item Weight | 6 g |
| Package Dimensions | 11.7 x 7.9 x 0.3 cm; 6 g |
| Item model number | T-d500 |
| Colour | Silver, White |
| Material | stainless steel,cable |
| Batteries included? | No |
| Batteries Required? | No |
K**N
Perfect!
Works as it should with my volcano above 285 degrees. Good accuracy too. At ambient my bed probe and this one shows the same temperature.
S**T
Does not provide correct readings no matter what Marlin firmware settings are used
I expected having to change my Marlin firmware to use setting 66 however this did not work as readings shown on printer were 80 degrees higher than actual hot end temperature. I tried setting 1000 with various resistances but the temperature was consistently lower by around 100 degrees. I even created a custom temperature table using a Excel spreadsheet I found online but after endless twiddling could not get the thermistor to give a reading anywhere near to the temperature at the hot end. I'm going to return the thermistor as not fit for purpose and would recommend others NOT to bother buying it.
ترست بايلوت
منذ شهرين
منذ شهر
