HornadyOne Shot Sonic Clean Solution, 1 Quart – Gun Cleaner Solution, Clean All Gun Parts Safely and Quickly – Designed for Use with Hornady Lock-N-Load Sonic Cleaners – Item 043360

This Hornady ultrasonic solution works great. Will buy again.

The cleaner is great for cleaning all firearms

I use this in both my degreaser station and sonic cleaner to clean up motorcycle parts, everything from calipers to crank case halves and cylinder heads. I bought it after consulting another motorcycle mechanic on what to use in my degreaser station, since I didn't want to hurt the paint, which mineral spirits (literally what is suggested in the manual) strips the paint within hours. This has sat for weeks to months in my station and never affected the paint, but the moment you send a part through the sonic cleaner the carbonization, dirt, and grease just disappear. Works great, last forever. Just be sure to wear gloves and dispose of it correctly.

Great product, a little longer to deliver than most Amazon orders but good price, good product.

This solution smells like a combination of GooGone and Simple Green. It works extremely well for cleaning firearms' parts. Be aware that it has a 40:1 dilution ratio and can be re-used several times, so no need to buy too much of it all at once. My two bottles are likely a lifetime supply! Hornady delivers on its sonic cleaner and solution - parts come out like a clay bar'd car finish! I plan on using it for BCGs, barrels, guide rods and return springs. Love it!

I've always been satisfied with all of their products from their safes, etc. Excellent company!!!

This is a concentrated product with a 40:1 dilution recommended. Thus 1qt makes 40 qts (10 gallons)of working solution.I use this about every 4-5 gun cleanings (or for prior to storage of gun for a while) to get the deeper grit and deposits that are difficult to get at with swabs and such.USE distilled water (any drugstore about $1.50 a gallon)If your ultrasonic cleaner does not have a heater, warm the water to about 80C (~ 180F) before mixing. Clean until you do not see any more dirt removal. I use a basket to keep parts from the water bed, and I strain my solution through a coffee filter after use. I can get several cleanings before recharging or replacing the solution. I store filtered working solution in a plastic coffee can, as I also use ultrasonic cleaner and different solution for brass.Parts must be rinsed, dried and lubricated before re-assembly (the complete ultrasonic cleaning process is not faster than brush, swab and rod cleaning, but much more thorough)I'd recommend using a silicon wipe-down cloth afterwards and not storing gun in a non-plastic holster or cloth.My cleaner size is large enough to hold a S&W K frame revolver so I can clean complete gun (less grips) at once.I have not noticed any issues with the polymer frame materials used on my S&W, Ruger, Sig or Taurus frames. I would not expect any with Glock, HK or others BUT test first to be sure.Again - this is a water based cleaning process - SO rinse, dry and lube parts before re-assembly, paying special attention to friction points on slide.Thanks for reading.

Works perfectly!

Awesome works well

Works as intended.nice product

Good product no complaints.. Shipping took longer then expected but that could have been due to holiday season.

thanks