🛢️ Seal the deal, save the fuel—never leak, always sleek!
This 6-pack of upgraded synthetic rubber gas can spout gasket seals offers universal compatibility with a wide range of plastic jerry cans and spouts. Engineered for superior durability and chemical resistance, these seals ensure leak-proof performance with gasoline, ethanol blends, diesel, kerosene, and fuel stabilizers. Designed for easy installation and cost-effective maintenance, they extend the life of your fuel containers without the need for full replacement.
O**1
Perfect fit
Perfect fit. Better quality than the original. No more leaks. Good price
J**Z
It fits
Works prefect on my gas cans with spouts
A**R
Works on roto pax
This was the second set i tried on my roto pax. These looked too small to start, but they fit tight and well. These seem to be actually a better option than factory.
C**M
DOES NOT fit the RotopaX RX-SP self-venting spout.
As car gaskets, these are fine but DO NOT fit the RotopaX RX-SP self-venting spout. They are too thin.
S**.
So far so good
Though the gaskets were a little snug, they fit on my gas can and are doing well for now. time will tell if they last but they are very affordable and I can easily replace With the other 5 gaskets in the very affordable pack that I purchased. I withheld a stR because I've only had the gaskets for a few weeks. My gas can is from Midwest Can Company. I would post a picture but the Amazon app only gives 2 options:"Allow this Amazon app to access your camera and skip this step in the future"OOORR"Allow this Amazon app to access your camera and skip this step in the future"So no pics, sorry. 😊
M**O
perfect!
These gaskets work on the scepter 1 gallon gas cans . They seal real well but are a little tricky to install .You must force them on ,kinda like screwing on nut , you will have to work a little but they are top notch !
K**B
Don't fit my Blitz nozzle, inner opening too narrow
Unfortunately, these do not fit properly on my Blitz safety nozzle (like the one 2nd from the left in their picture.) The reason is that the inner groove is too narrow. It is about one third of the thickness of the gasket, but my original one has a wider groove (and the same total thickness.) I can fit it onto the end of the nozzle, but since it does not fit quite right, when I try to screw it onto the can, the gasket gets pushed off the end of the nozzle and obviously does not seal.
C**Z
Parts that fit
Actual parts that fit
ترست بايلوت
منذ يوم واحد
منذ أسبوعين
