LASFIT 921 LED Bulb Reverse Lights, 912 T15 Back Up Light CANBUS Error Free W16W 906 Reversing Bulb 904 916 6000K Xenon White New Upgrade Design, Plug and Play (Pack of 2)

These reverse lights are awesome. My old halogen lights sucked very hard to see at night. These are so bright and really light up whats behind you. Fits my 2025 Colorado Trail Boss perfectly. If they don’t come on just flip the light around.

Fits my Lexus ES. Super bright. One bulb failed after almost a year. LastFit Customer service responded to my inquiry the same day. Vendor stands by warranty and sent replacement upon my reporting.

Use in my 2011 XTERRA reverse lights. They were a very tight fit through the hole, but did fit ok. The light output far exceeds the LED bulb from Super Bright LEDS that they replaced. I would describe them as being like clear fog lamps in back. The old LEDs were overpowered by halogen brake lights, but with these, I don't see any red glow due to the brightness (from backup camera view).

Excelente producto, lo recomiendo al 100%… lo compré para mi Toyota Highlander 2022 y funciona a la perfección.

Works as described, time will tell since I've only installed a week ago. Very bright compared to the one installed on my 2020 CRV.

These are very bright, and they do include an internal resistor. Those benefits earn it 2 stars. Unfortunately, the internal resistors do not prevent them from hyperflashing entirely, so I believe that the resitor has too low of a value. What happens is this: it flashes normally for 20-30 seconds, and then begins hyper-flashing. When I turn on the turn signal, it flashes normally for a short while. If I use the lane-change setting for the turn signal that flashes 4 times and stops, all is fine. If I turn on the turn signal as I'm approaching an intersection, and I complete the turn right away, all is fine. If I pull up to a stop light and I'm sitting for 30+ seconds, the flashing becomes erratic - sometimes hyper-flash, sometimes not. The flashing is all over the place at this point. If I turn it off and then turn it right back on, it's still flashing erratically. If I turn it off for a few minutes, it goes back to normal for short uses.Since the hyper-flashing occurs on both the left and right signals, it tells me that it's a design flaw. I suggest trying a different manufacturer.EDIT:The manufacturer was very gracious and contacted me. I should note that I have used Lasfit LED lights elsewhere in my vehicles and the others function great. It's just the turn signals in my truck where they have a problem.2nd EDIT:It's very difficult to find this bulb in red, with a built-in resistor. In fact, it's the only one I could find. Since I still needed it, I left it installed and then added a second resistor to it. I added the Sylvania 27 watt (https://www.amazon.com/dp/B01A77U122 ) and have not had any problems since then. My advice is if you need a red T15/912, order this and see if the resistor is enough for your vehicle. If so, great! If not, you can add a resistor and it should work fine.

Very bright, no rapid blink. These fit perfectly into my 2020 Toyota 4Runner for reverse lights!!

The bulb is very good, I recommend it. Now my lights shine much brighter. 5 stars.