4Pcs UCP204-12 Pillow Block Bearing 3/4 inch Bore Mounted Pillow Block Bearings Chrome Steel Bearings with 3/4" Bore, Self Alignment

Time will tell how these last, but up front: the castings are a little rough, but seems to be sturdy, bearings snuggly accepted a 3/4" cold rolled shaft.

Used this to mount the spindle for a diy lathe. Very happy with it. Accuracy of the bearing id was good. Measued exactly 1.25" on my calipers. Only drawback was a slight burr on the inside of the screw thread, which took a little bit of work to sand smooth but that wasn't too much of an issue.

I bought these as replacement for my 4200lp kmc caking machine for litter for the pickup bar and they are just a little lighter duty but for the price I can buy 6sets of these for just one factory bearing so these have worked so far so good

I installed it and there were no problems, but time will tell whether it is durable or not. It is working fine for now. If there is any problem, I will inform you immediately.

These are exactly what I needed for my project. I was surprised I had to install the oil plug and yellow cap manually, but it's ok. Not sure what oil to use, or how I would fill these up, but I'll research that at some point.

Works great for a metal project I made for my gym.

Perform as it should.

Purchased these bearings to upgrade my lawn roller. To acutally use them I had to remove material from the center shaft (measured .9992" with a micrometer). I spent approx 15 - 20 mins on each side of the lawn roller with emery cloth to provide clearance to make these bearings fit. When finished, the axle measured .9844 and .9841. The bearings were bumped on with a brass hammer although even with the axle measurement less than 1.00 inch it did take a few good whacks to seat them on the axle. I did not tighten the mounting bolts very much because of the hollow area around the mounting tab in the cast housing for fear of breaking the housing. The bearings are working on the lawn roller and should provide adequate strength to provide long life with proper lubrication. I would have given a much high score if these bearings would have provided a true 1.00" bore and thicker cast iron mounting housing.

I read some reviews about missing parts… the four bearings I got were very well packed and with all the expected components. I did not yet use them, but the look and feel is very good. the center includes two set screws for fixing the motor shaft.

The media could not be loaded.

tel que vue bonne qualiterclaude W

Je dois essayer de retourner car pas la bonne ouverture pour le "shaft", possiblement mauvaise conversion des mesures anglaises à métriquesMais bonne conception, solide, belle apparence, livraison rapide,

used them on a small home made cart, dont know the quality or how long they will last but so far so good, they are greaseable so at least I can service them!