kawish Full Automatic Car Battery Charger 12V/24V 10Amp Intelligent Pulse Repair Battery Charger Truck Motorcycle Charger

kawish Full Automatic Car Battery Charger 12V/24V 10Amp Intelligent Pulse Repair Battery Charger Truck Motorcycle Charger

Q: could I use this as a 12v power supply to run some 12v fans lights and a pump? all less than 5 amps total.

Yes, sometimes I use it as a dc power supply, but the output voltage is not 12V, when the output current is 10A the voltage is 13V when the output current is 5A the voltage is 13.4V when the output current is 1A, the voltage is 13.9v,so you should know if the fans lights and pump can work at these voltages,

Q: Do this charger plug in to a ac outlet

Yes, it plugs into a 110V outlet. However, it is a small charger and will take time to charge a car battery. We use it on a lift battery charger where it is always on line and charging as needed.

Q: What is the lowest charge setting? Can it go as low as 1A charge?

I'd say use a zero amp charge, as the one and only time I used it, it completely destroyed a fairly new $135 battery. I returned it.

4.2/5

معرّف المنتج: 146730503

معاملة آمنة

التفاصيل

Brand
Kawish
Color
Red
Product Dimensions
2.76"D x x
Item Weight
0.85 Kilograms
Output Voltage
14.1 Volts

يُشترى معًا بشكل متكرر

Kawish Full Automatic Car Battery Charger 12V/10A | 24V/7.5A Intelligent Pulse Repair Battery Charger Truck Motorcycle Charger with Terminal Clean Brush for Automotive,Boat,Motorcycle

GTC063 Fuse Socket Connector Kit by GTC, General Technologies Corp

Auto Car Truck Wire Piercing Cord Voltage Circuit Tester DC 6V/12V/24V Hook Probe Test Light Pencil with Light Indicator 1pc

الوصف

This charger Maximum current is 10A, It takes about 5-7 hours to fully charge a car battery
This charger has 5 kinds of charge status,From Constant Current Mode to Constant Voltage Mode to Float Mode to Trickle Mode to Idle Mode and Then Stop charging ,The stop voltage is 14.1V
This charger can display charge voltage ,Current,And electricity ,
Except Auto Mode,this charger have Manual mode ,it's use the 16.3V to charge the battery，For emergency situations, fast charging ，and it's better not charger long time at this mode , it will overcharge the battery
At last ,this charger is a very safety ,it have 4 protection , 1,Reverse connection protection 2, Low voltage protection 3, Overheat protection 4,Short circuit protection
›See more product details

Intelligent Pulse Repair Battery Charger Parameters: 1. Input Voltage: 110-230V 2. Output voltage: 12V/24V 3. Current:10A peak for 12V,8A peak for 24V 4. Suitable capacity: 30-120AH 5. Power:120W 6. Frequency: 50-60HZ 7. Length of output wire:65cm 8. Length of input wire:125cm 9. Dimension: 14*19*7cm 10. Gross weight: 0.9kg 11. Application: best suitable for 40-120AH lead acid batteries(including wet and dry) Multiple protections Overheat protection: The charger will close automatically without current output for protective purpose when its temperature is over 105℃, and when the temperature is decreased below about 80℃ or power supply is shut down for 10 minutes, charging process can be resumed. Short circuit protection: In case of accidental short circuit, the charger will close automatically without current output, and beep for alarming. Once correctly connected, charging process will be resumed. Reverse connection protection: Whenever positive poles and negative poles of the charger and the battery are not connected correctly, the charger will close automatically without current output, and beep for alarming. Once correctly connected, charging process will be resumed. Low voltage protection: When single cell voltage is below 1.5V, the charger can not be started up, and beep for alarming. This mechanism is to avoid possible damages caused up by voltage discrepancy between the battery and the charger.