Flexzilla Pro Air Hose Reusable Fitting, 3/8 in. - RP900375

I bought an air hose spool that mounts on the wall of my garage. Very convenient until the fitting that came with it somehow got bent and blew off. I didn’t want to buy a whole new spool assembly, nor did I want to buy an expensive crimping tool that I’d only use once. When I discovered this life saver, it was too affordable not to try. It was harder to install than I thought it would be. Getting the tip to grab the inside of the air hose proved a challenge. After a short struggle I could never get it flush mounted, until once I started to secure the nut that holds it together. It looked pretty secure after tightening the nut, and I’ve used it with my compressor 5-6 times since the repair, and it’s still holding strong. Compared to buying a new air hose or have a new fitting professionally installed/repaired, this was too good of a price not to try. The product quality is great and this is brilliantly designed. I did a lot of searches before finding this, so let’s hope they advertise better in the future.

I bought several, I've only used two, but they're very easy to install and super affordable. I used to pay quite a lot for those adapters until I found these.

Worked well for my broken hose

I used this on a generic hose i think i got from the orange big box store. It was a very snug fit, and i had to cut the bottom ring open since it's slightly narrower than the aluminum fitting ID. I thought that was s little odd, but granted this was intended for their products. Strain relief still works and the ring is tough enough it's not going to pop open. Machining is good. Went together well. Holding pressure. Apart from wishing it was a touch more universal in fit, it was loads cheaper than a new hose.

Excellent product, well made, easy to use.

Good fix.

I decided to rate based on ease of installation and features so take in to consideration that I just installed and do not have long term use with this product. Used a dab of grease on barb to push hose over barb and tightened (pre-installed) nut over top of barb fitting until nut bottomed out against barb fitting and clipped (pre-installed) hose wrap into back side of nut. Went together easily and I like the hose wrap on the back side. I pressure tested to 150 psi (the max for my air compressor) and did not leak. Also pulled on hose a little while under pressure and seems to hold well. Would buy again if needed.

The best I ever used