Magister Hydraulics Double Acting Hydraulic Cylinder - Cross Tube Hydraulic Cylinder 2.5" Bore 24" Stroke - UniversalHydraulic Cylinders (2.5x24)

Had to modify them to fit my bobcat but they work like new

I have a low hour mid 80s Kabuto b6200 with a 1640 front end loader. The bucket rams started to leak bad and there is no rebuild kit or replacements online. Found this with the correct measurements. Just needed a few washers for shims at the pins and the hose adapters. I used BEITERSTOE (2-PACK) 6901-06-06-NWO Hydraulic Hose Adapter Fitting 3/8"Male Adjustable Nut O-Ring Boss(9/16"-18UNF)×3/8"Female Swivel(3/8"-18NPSM)90° Elbow SAE Pipe Joints Tube Connector Carbon Steel found here on Amazon. Works great.

Cylinder works perfect on my woods 750 backhoe, saved over 400.00 from a woods replacement cylinder, know complaints

This hydraulic cylinder works great, but arrived with some of the paint chipped and rubbed off because of poor packaging. This cylinder is quite heavy and the only protection it had was one layer of very small bubble wrap. For nearly $300 I would expect better packaging, at least some paper or something to keep it from rolling around loosely in the box.

This was a close replacement for a grapple arm cylinder that was leaking. It was less expensive to buy new than to have the old one repaired. I could not find an exact match (except for length) and had to find fittings, a new pin and some bushings to make it work and it does. No leaks and seems a little more responsive than the original.

Bought when on sale so was a good price for a quality cylinder.

This hydraulic cylinder seems extremely well built. Be sure to check the location of hydraulic hose fittings.

I matched the dimensions to my existing cylinders and it was a perfect fit. Finally putting my small front-end loader to work. Thanks.