G 1/4inch Cooling Heat Exchanger CO2 DC12V 10W CPU 500L/H Quiet Working 50000 Hours Life

I changed rating from 3 stars to 5 stars, due to their fantastic customer service.With this competitive price, they care their customers, which is amazing. When I have complained about inaccurate information between item and which showed in the pic, also some potential flaw of the item, they partial refunded me, and apologized.Again, you will spend another $10 for the high quality fittings to prevent from any potential leakage, but at this price, this pump is a very good entry level starter must have.====above is updated====So far so good. It has been run for 24 hours till now, nothing wrong yet, will keep tracking it to help people who is seeking cheap water cooling pump.This is pretty much the cheapest pump with reservoir that has decent specs (bought it for $31), pump rate is good enough, reservoir is 250 ml which is good enough, and it has a replaceable fitting. You don't need big reservoir for cooling until you really like one. As people said, the fittings are smaller than g1/4", I bought xspc barb fittings and xspc tubing (3mm wall) to avoid potential leakage. These two are the most possible leakage places in a custom loop. I did rinse the reservoir, which is really difficult to do, twice before setting the loop.Use the custom loop to replace previous air cooler (scythe Fuma, which is not a bad one, but recently the temp started to raise, not sure if it was a defective or what, so returned it), went smooth and well. With air cooler 3770k @4.6Ghz, max temp was 80+ c with turbo fan speed. Now @4.7Ghz (Vcore went up 0.05v) max temp was 75 c with silent fan speed. This pump was no where to screw on, so I put it on a piece of foam, and taped it to my psu (CM trooper). Very quiet, and if someone complain about the vibration noise, try to fold a paper towel and cushion it, the noise would be gone immediately. Not sure how long it will last, and I don't have a indicator in my loop, but will keep updating.Btw, when it arrived, it was wrapped well in a bubble foam plastic, the first touch feels decent quality.

I purchased this combo in hopes for a very budget cooling system. It looks great, and the bard fittings come off, so you can put hard line tubing fittings in this pump.I used this for hard line. I finished my whole loop and filled it up. Worked great for the 1st day. On day 2 my system started shutting down on me. I decided to monitor the temps, and noticed it was over heating like crazy. I put my hand on the tubing by my cpu, and both sides were burning hot. The pump died in less than a day. I returned it, and went with XSPC (which is what i should have done from the get go)Buyers Beware!!!! This pump is horrible, and garbage. DO NOT BE FOOLED BY THE PRICE. Its not worth any kind of money what so ever.

The first thing I did is change out the barb fittings that came with it as they didn't hold well onto my tubing I didn't even bother to try to leak test them, beyond that it's about as good as you can expect to get for the price. I've had no problems with it although I did heed the advice of other reviewers and not overtighten the cylinder etc. during installation. The pressure is good, it keeps my system at 25C idle, it's quiet enough that I can't hear it running. It's a submersible pump so it's important to not let it run dry when you're filling your system, I have read some comments about pump noise and I'm wondering if that was the cause as mine is all but silent. The mounts provided hold the reservoir in place solidly though I'll note that they differ from the ones pictured as the ones I got were clear clip style and not the black ones shown, not really an issue for me.All in all I'd recommend it, if I was building a second loop I would buy another one of these.

While surfing through the reviews I have noticed that many complains about their pump that failed.So was mine as well, the pump died approximately after two months of use.I filled the tank with distilled water.No residues or deposits were found during the loop disassembly while replacing the failed pump, so the water was perfectly fine.After I contacted the seller he offered me a replace or a refund, but after that he never got back to me again, so I had to reach out to Amazon support.Since I already replaced the pump, I choose the refund.But nevertheless, to be fair, the pump was doing a great job at the time it was working, with barely noticeable noise... So it could be that some units are just having some factory defects that shows over time, idk...You can give it a try, for the price this is a pretty decent pump, unless you are unfortunate enough to receive a failure unit.

I bought this liquid coolant pump with built-in reservoir tank to replace the stock pump and reservoir that came with my Bitmaintech Antminer C1 liquid cooled Bitcoin mining ASIC after the factory parts failed spectacularly and unexpectedly. The Yosoo unit is an improvement over the included liquid cooling hardware that Bitmain ships in many ways: the pump itself moves more liquid and does it faster than the original; compared to others it holds much more coolant, and is significantly quieter as well. This liquid cooling pump comes with a built in reservoir, making the use and installation of (what can be) a complex PC cooling solution just that much easier. The pump itself is fairly quiet and the liquid coolant reservoir is more than sufficient for several months of continuous use without the need to top up the amount of coolant constantly. I highly recommend this pump + reservoir combo for anyone who is considering liquid cooling a computer, whether it is their first time or 1,000th install!

gut

BonjourJe voudrait savoir quelle embout pour raccordé les sortie au tuyau il faut prendre ?

still running after nearly a year non stop.

Partiamo con il dire che ho solo cose positive da elencare per questa piccola, ma potente, pompa con serbatoio.Ormai sono più di due anni che la uso su un sistema con un Threadripper 2950x e due 1080 in SLI, il tutto raffreddato da due radiatori, uno da 360x45mm e l'altro da 240x38mm.Smentisco quindi le falsità sulla scarsa affidabilità e potenza di questa particolare pompa.Arriva a 3200g/min e si collega ad una porta delle ventole della scheda madre, potendo quindi cambiare il regime di rotazione a piacere, se se ne ha la necessità.Concludo dicendo che, anche al massimo dei giri, non emette alcun rumore e non si scalda, quindi la consiglio assolutamente.

la bomba funciona de maximo a 3000 rpm , haciendo un ligero zumbido , casi inaudible , los soportes son de tipo garra . Llegó envuelta en papel burbuja y flim transparente, Tanto cuesta una caja ??Su funcionamiento de momento es impecable, la tengo montada con un radiador de 360+120 con bloque de gpu y cpu, y al 70%(2700rmp) me está dando un caudal de 280l/h a la salida del radiador de 360mm, más que suficiente.llevo usando a diario más de 8 meses y de momento genial.