End Mill Set, 10 pieces 2 & 4 Flute

These mills produce a terrible finnish even on soft metals such as aluminum, on steel alloys you will NOT want to use these for a finishing pass. Two have already broken on me with only being used twice. The wood case they come in sounds like a great thing until the wood swells onto the shank making it impossible to remove without wrapping the mill in a rag and using a pliers to remove it. Pay the extra money for a Niagara cutter. They are made in America and the quality is multiple times better. They are cheap, that sums up the "good" side of this purchase.

Not so expensive so I was not expecting top quality. However as I was planning to machine aluminum and brass, I thought no big deal. Of course the first job I did was a 5/8 hot roll steel sub-plate for my rotary table. :-) Anyway, the tooling did the job and held up just fine. The case they come in is not quite as nice as shown, but no deal breaker.

I may not be an experienced-enough machinist to appreciate the nuances between this set and something of "higher quality", but I can say that for the price you pay for this set, as compared to buying your end mills individual, the bang-for-the-buck is exceptional.

Not exactly the best, but pretty hard to beat for the price. They have stood up better than I thought they might. The wooden container is reusable and definitely something you don't want to discard. I would buy these again.

so far i've milled some aluminum with both the 2 anf 4 flute mills and they have worked well and are still sharp. a good deal for very little money.

Super High quality, The Use from these, had no problems thus far.

love it!

on time good price and worked well for teaching new operator's